Robust housing offering superb durability to help prevent
damage to unit. Featuring Thirty six super bright LEDs.
Thirty LEDs used as an inspection lamp or Six LEDs in the
end for use as a directional torch. Single LED battery indi-
cator. Smooth rocker switch for turning unit on/off. 360°
Swivel hanging hook for hands free applications. Supplied
with mains and 12V in-car chargers.
InSTRucTIon MAnuAL FoR:
CORDLESS INSPECTION LAMP
MoDEL no:
LED3006
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained,
give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
2. INTRODUCTION
1.1 GENERAL
Ensure the torch is correctly charged before initial use.
DO NOT
turn the torch on when it is being re-charged.
DO NOT
shine directly into your, other person’s or animal’s eyes.
DO NOT
allow children to use the torch.
DO NOT
handle or move the torch whilst it is being charged.
DO NOT
use the torch if you suspect that the battery or the torch casing is damaged.
DO NOT
leave battery in a discharged state, recharge battery immediately. If the torch is not in use,
recharge the battery every month.
1.2 ELECTRICAL SAFETY FOR USE OF CHARGER.
USE ONLY THE SUPPLIED CHARGER PLUG FOR
CONNECTING TORCH TO THE POWER SUPPLY.
WARNING!
It is the user’s responsibility to read, understand and comply with the following electrical
instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An RccB (Residual current circuit Breaker) should be incorporated in the main distribution board. We
also recommend that an RcD (Residual current Device) is used with all electrical products, particularly
portable equipment which is plugged into an electrical supply not protected by an RccB.
You must
also read and understand the following instructions concerning electrical safety.
1.2.1
The Electricity At Work Act 1989
requires all portable electrical appliances, if used on business
premises, to be tested by a qualified electrician, using a Portable Appliance Tester (PAT), at least once a
year.
1.2.2 The Health & Safety at Work Act 1974
makes owners of electrical appliances responsible for the safe
condition of the appliance and the safety of the appliance operator.
If in any doubt about electrical safety, contact a qualified electrician.
1.2.3 You must ensure that you:
Inspect the charger plug, cable and connector for wear and
damage to ensure items are safe before connecting to the mains power supply. If worn or damaged
DO
NOT
use.
Important: check that the voltage marked on the charger plug is the same as the power supply to be
used.
uncoil the cable between charger and the torch.
DO NOT
pull the charger plug from the mains socket by the lead.
DO NOT
use any other type of charger with this product.
DO NOT
try to take the charger plug apart.
DO NOT
use the charger plug to charge or power any other electrical item.
DO NOT
get the charger wet, or use in wet, damp conditions (for indoor use only).
WARNING!
NEVER
substitute a standard 13amp 3 pin plug, or any other type of plug, for the charger
plug.
Original Language Version
LED3006 Issue: 3 - 06/01/12
