instructions for
rechargeable 360
°
slim inspection lamp
16smd led + 1w led lithium-ion
model no:
led3604 series
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
9
inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. if worn or
damaged
do not
use.
9
ensure the torch is fully charged before initial use.
8
do not
charge in damp conditions.
8
do not
turn the torch on when it is being charged.
8
do not
shine directly into your, another person’s or an animal’s eyes.
8
do not
allow children to use the torch.
8
do not
handle or move the torch whilst it is being charged.
8
do not
use the torch if you suspect that the battery or the torch casing is damaged.
8
do not
leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
8
do not
attempt to open, disassemble, modify or service the battery pack.
8
do not
crush, puncture, short external contacts or dispose of in fire or water.
9
replace only with the battery pack designated for this product.
9
recycle or dispose of used battery as stipulated by local regulation.
9
if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. introduction
unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. exclusive patented design
owned by and registered to sealey. each lamp houses 16 super bright smd leds providing up to 600 lumens through the adjustable rotary
switch and a 1W smd led directional torch. features a single hanging hook, a magnetic base allowing hands free operation and battery level
indicator. High quality 2.6Ah 3.7V lithium-ion battery for longer life, no memory effect and a much slower discharge than traditional ni-mH
batteries. supplied with a high quality braided usB lead.
3. specification
model no ...................................................... led3604 series
Battery ........................................................3.7V 2.6Ah li-ion
led Quantity ................................................ 16 smd + 1led
lumen output side (high/low)/top ................. (600/50)/120lm
operating time side (high/low)top ......................(1.5/16)/10hr
iP rating .........................................................................iP54
iK rating .........................................................................iK07
minimum length ......................................................... 390mm
maximum length ........................................................ 400mm
important warranty information
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish.
under these circumstances we will not replace the battery regardless of whether the battery less than one year old.
4. operation
4.1.
CHARGING (fig.2)
4.1.1.
remove usB socket cover from the side of the lamp.
4.1.2.
connect the usB lead to the port on the side of the lamp and a usB power socket. turn on the power supply.
4.1.3.
The battery charge level LED on the side of the lamp will flash green and show the level of charge.
4.1.4.
When the battery has fully charged all the led’s will turn Green.
4.1.5.
switch off power supply, remove charging lead and replace socket cover.
led3604 series | issue 1 23/05/17
Original Language Version
© Jack sealey limited
refer to
instructions
