instructions for
RoadstaRt®emeRgency jump staRteR
12/24V 6ltR 8 cylindeR.
model no:
Rs105B.
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
impoRtant:
to reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. remember to review warning marks on all products and on
engines. Modern vehicles contain extensive electronic systems. Check with the vehicle manufacturer for any specific instructions regarding the
use of this type of equipment on each vehicle. no liability will be accepted for damage/injury where this product is not used in accordance with
all instructions.
1.1.
safety instRuctions
9
Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.
9
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool,
clean running water for at least 15 minutes and seek immediate medical attention.
9
remove personal metallic items such as rings, bracelets, necklaces and watches.
9
Keep the unit in good working order and condition. replace damaged parts immediately.
9
use only recommended parts. to use unapproved parts may be dangerous and will invalidate your warranty.
9
The RoadStart must only be opened and checked by qualified service personnel.
do not
disassemble the unit for any reason.
9
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials. ensure that there is adequate lighting.
9
If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.
8
do not
smoke or allow a spark, or flame in the vicinity of the battery or engine.
8
do not
drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.
8
do not
use roadstart to recharge dry cell batteries that are commonly used with home appliances.
8
do not
charge or boost a frozen battery.
8
do not
use attachments other than those recommended.
8
do not
pull or carry the unit by its cables and
do not
pull the negative and positive clamps from the battery terminals.
8
do not
operate in vicinity of flammable liquids or gases.
8
do not
recharge the unit with a charger / cables that are damaged. replace immediately.
8
do not
use this product to perform a task for which it is not designed.
8
do not
store the unit in damp or wet locations or where the temperature may exceed 50°c.
8
do not
submerge the unit in water.
8
do not
use whilst under the influence of drugs, alcohol or intoxicating medication.
8
do not
leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage.
8
do not
cross-connect the power leads from the roadstart to the battery. ensure that positive is to positive and negative is to
negative.
9
ensure that the unit is fully charged before storage. Keep the unit fully charged on a regular basis.
1.2.
electRical safety
(with respect to mains chargers)
WaRning!
it is the user’s responsibility to check the following:
You must check the Ac adaptor to ensure that it is safe before using. You must inspect the power supply lead, plugs and all
electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of
appropriate safety devices. An rccB (residual current circuit Breaker) should be incorporated in the main distribution board.
We recommend that an rcd (residual current device) is used with all electrical products. it is particularly important to
use an RCD with portable products that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified
electrician. You can obtain a residual current device through your sealey dealer. You must read and understand instructions
concerning electrical safety.
the
electricity at Work act 1989
requires all portable electrical appliances, if used on business premises, to be tested by a
qualified person, using a Portable Appliance Tester (PAT), at least once a year.
the Health & safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
9
ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply.
9
en
sure that cables are always protected against short circuit and overload.
rs105B | issue 1 18/01/18
Original Language Version
© Jack sealey limited
refer to
instructions
electrical
shock
hazard
Wear eye
protection
Wear protective
gloves
Warning
corrosive
substance
Keep away
from sources
of ignition
use in well
ventilated
areas
Keep in dry
area protect
from rain
Warning
