background image

instructions for

RoadstaRt®emeRgency jump staRteR 

12V 2ltR 4 cylindeR/3.5ltR 6 cylindeR 

5ltR 8 cylindeR petRol.

model no: 

Rs1B, Rs102B, Rs103B.

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these 

instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT:

 PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE 

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1.  safety  

impoRtant:

 to reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the 

manufacturer of any equipment you intend to use in the vicinity of the battery. remember to review warning marks on all products and on 

engines. Modern vehicles contain extensive electronic systems. Check with the vehicle manufacturer for any specific instructions regarding the 

use of this type of equipment on each vehicle. no liability will be accepted for damage/injury where this product is not used in accordance with 

all instructions.

1.1.    

safety instRuctions

 

9

   Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.

 

9

   Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool,  

  clean running water for at least 15 minutes and seek immediate medical attention.

 

9

   remove personal metallic items such as rings, bracelets, necklaces and watches. 

 

9

   Keep the unit in good working order and condition. replace damaged parts immediately.

 

9

   use only recommended parts. to use unapproved parts may be dangerous and will invalidate your warranty. 

 

9

   The RoadStart must only be opened and checked by qualified service personnel. 

do not

 disassemble the unit for any reason. 

 

9

   Keep children and unauthorised persons away from the work area.

 

9

   Keep work area clean and tidy and free from unrelated materials. ensure that there is adequate lighting.

 

9

   If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.

 

8

  

do not

 smoke or allow a spark, or flame in the vicinity of the battery or engine.

 

8

  

do not

 drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion. 

 

8

  

do not

 use roadstart to recharge dry cell batteries that are commonly used with home appliances. 

 

8

   do  not 

charge or boost a frozen battery.

 

8

  

do not

 use attachments other than those recommended.  

 

8

  

do not

 pull or carry the unit by its cables and 

do not 

pull the negative and positive clamps from the battery terminals.

 

8

  

do not

 operate in vicinity of flammable liquids or gases.

 

8

  

do not

 recharge the unit with a charger / cables that are damaged. replace immediately.

 

8

  

do not

 use this product to perform a task for which it is not designed.

 

8

  

do not

 store the unit in damp or wet locations or where the temperature may exceed 50°c.

 

8

  

do not

 submerge the unit in water.

 

8

  

do not

 use whilst under the influence of drugs, alcohol or intoxicating medication.

 

8

  

do not

 leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage.

 

8

    

do not

 cross-connect the power leads from the roadstart to the battery. ensure that positive is to positive and negative is to    

 negative. 

 

9

   ensure that the unit is fully charged before storage. Keep the unit fully charged on a regular basis. 

1.2.    

electRical  safety

 (with respect to mains chargers)

 

‰

  

WaRning!

 it is the user’s responsibility to check the following:

 

You must check the Ac adaptor to ensure that it is safe before using. You must inspect the power supply lead, plugs and all 

 

electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of  

 

appropriate safety devices. An rccB (residual current circuit Breaker) should be incorporated in the main distribution board.    

 

We recommend that an rcd (residual current device) is used with all electrical products. it is particularly important to  

 

 

use  an RCD with portable products that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified 

 

electrician. You can obtain a residual current device through your sealey dealer. You must read and understand instructions  

 

 

concerning electrical safety.

 the 

electricity at Work act 1989

 requires all portable electrical appliances, if used on business premises, to be tested by a  

 

 

qualified person, using a Portable Appliance Tester (PAT), at least once a year.

 

the Health & safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and  

 

the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.

 

9

   ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply. 

 

9

   en

sure that cables are always protected against short circuit and overload.

rs1B, rs102B, rs103B | issue 1 16/01/18

Original Language Version

© Jack sealey limited

      refer to

   instructions

      electrical

        shock

       hazard

 Wear eye

protection

 Wear protective

gloves

 Warning

corrosive 

substance

 Keep away

 from sources

 of ignition

 use in well 

ventilated

areas

 Keep in dry 

area protect 

from rain

 Warning

Reviews: