Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
SA58.V2 Issue: 3(HF) - 21/11/18
Original Language Version
© Jack Sealey Limited
Refer to instruction
manual
Wear eye
protection
Wear protective
gloves
Wear ear
protection
Wear a
mask
AIR PISTOL SCREWDRIVER
MODEL NO:
SA58.V2
1. SAFETY
WARNING!
Disconnect from air supply before changing accessories or servicing.
WARNING!
Check correct air pressure is maintained and not exceeded. We recommend 90psi.
WARNING!
DO NOT
use screwdriver if damaged or faulty. Contact your local service agent.
DO NOT
use the screwdriver for a task it is not designed to perform.
DO NOT
hold the workpiece by hand. Use clamps or a vice to secure the workpiece.
D
O NOT
use screwdriver unless you have been instructed in its use by a qualified person.
DO NOT
drop, throw or abuse the screwdriver.
DO NOT
carry the screwdriver by the air hose, or pull the hose from the air supply.
DO NOT
operate screwdriver if you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT
carry screwdriver with your hand on the power trigger in order to avoid unintentional starting.
DO NOT
direct air from the air hose at yourself or others.
Follow all workshop health & safety rules, regulations, and conditions when using screwdriver.
Maintain screwdriver in good condition and replace any damaged or worn parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure that all connections are secure.
Keep screwdriver bits clean and in good condition for best and safest performance.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip footwear.
Keep children and unauthorised persons away from the working area.
Ensure the screwdriver bit is secure in the chuck.
Wear approved safety eye and ear protection.
Avoid unintentional starting.
When not in use disconnect from air supply and store in a safe, dry, childproof location.
2. INTRODUCTION
Pistol grip style, air operated screwdriver with reverse control. Positive clutch gives up to 115lb.in of torque. Suitable for assembly/dismantling
and general production work. Features 1/4”Hex quick release chuck for fast bit changes.
3. SPECIFICATION
MODEL NO:
................................................................................................................
SA58.V2
Chuck size: ................................................................................. 1/4”Hex Quick-Release Type
Maximum torque: ..........................................................................................................115lb.in
Free speed: ................................................................................................................ 1500rpm
Air consumption: .............................................................................................................. 4cfm
Operating pressure: ......................................................................................................... 90psi
Air inlet size:............................................................................................................... 1/4” BSP
Weight: ............................................................................................................................. 1.2kg
Noise power: ..............................................................................................................102dB(A)
Noise pressure: ............................................................................................................91dB(A)
Vibration: .....................................................................................................................3.27m/s²
Uncertainty: ...................................................................................................................1.5m/s²
