ELECTRONIC KEY CABINETS
model no:
SEKC25, SEKC50, SEKC100
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
1. SAFETY
WARNING!
These cabinets are heavy and care should be exercised in transit and handling to ensure that no one is injured.
WARNING!
These key cabinets are a 2 person job for installation.
9
For maximum security, these cabinets must be securely fixed to a wall.
9
Ensure that any wall used is sufficiently strong to carry the weight of the cabinet and its contents.
8
DO NOT
install in areas where damp and condensation are present.
WARNING!
The warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this product,
but must be applied by the operator.
2. INTRODUCTION
H
eavy-duty construction with twin locking bolts. Simple to operate electronic keypad accepts numbers of between three and eight digits, giving
millions of combinations. Three LEDs show security, power and operating status.
A
lso supplied with two keys for manual override should batteries fail. Numbered, colour coded hook bars are adjustable to suit varying key
sizes. Includes anchor bolts.
•
CAUTION:
If you, or an intruder, uses an incorrect group of numbers, the cabinet will not open and a yellow light will illuminate. Entering
an incorrect PIN 3 times will freeze the system for 20 seconds.
•
Keep the cabinet key and any record of the combination separate from the cabinet and unidentified.
3. SPECIFICATION
model no. .................................................................
SEKC25
overall size .............................................
320 x 120 x 210mm
K
ey capacity .......................................................................
25
4. INSTALLATION
4.1.
Consideration should be given to the placing of the cabinet to ensure
that it is placed in a discreet location and will not be easily found by intruders.
4.2.
Each cabinet is supplied with two anchor bolts suitable for fixing to brick and
concrete.
4.3.
Fixing to hollow partition walls is not recommended. If fixed to wood it must
be to a solid wooden structure.
4.4.
open the door of the cabinet
(see 5.1 / 5.3 for opening instructions)
and
with the help of a second person, position it where required and mark the
mounting positions through the pre-drilled holes in the back of the cabinet.
4.5.
When mounting to a wall, ensure that the cabinet is adequately supported
during the marking process.
4.6.
Drill 10mm holes to a depth of 38mm (fig.1.1) and insert the anchor bolts
with nuts and washers removed (fig.1.2). Wear appropriate PPE (goggles
and mask.)
4.7.
Position the cabinet over the two protruding mounting studs and support it
there whilst placing a washer, split washer and nut onto each stud (fig.1.3).
4.8.
Continue to support the cabinet whilst tightening the fixings (fig.1.4).
SEKC25, SEKC50, SEKC100 | Issue:5 (H4F) 16/04/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
model no. .................................................................
SEKC50
overall size .............................................
400 x 120 x 340mm
K
ey capacity .......................................................................
50
model no. ...............................................................
SEKC100
overall size .............................................
400 x 120 x 550mm
K
ey capacity .....................................................................
100
fig.1
