Key LocK Security Safe
Model no:
SKS01, SKS02 & SKS04
thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. Safety
WarNiNG!
These safes are heavy and care should be exercised in transit and handling to ensure that no one is injured.
WarNiNG!
The SKS04 is a 2 man lift both for transit and installation.
9
For maximum security, these safes must be securely fixed to a floor and/or wall. At all times, these safes should be positioned on a
level floor/surface.
8
Do Not
install in areas where damp and condensation are present.
2. iNtroDuctioN
H
eavy-duty steel construction with twin locking bolts. Powder coated finish to help prevent corrosion. Compact design, pre-drilled holes and
security fixings allow safe to be fixed to the floor and/or to the wall and hidden away discreetly. Model numbers SKS02 and SKS04 include a
single shelf to help utilize the area inside the safe. Supplied with two keys.
3. SpecificatioN
Model no: ...................................................................SKS01 ................................................SKS02 ............................................ SKS04
external dimensions (W x d x H): ...........350 x 250 x 250mm ............................380 x 300 x 300mm ........................ 350 x 330 x 500mm
Internal dimensions (W x d x H): ............345 x 230 x 245mm ............................375 x 280 x 295mm ........................ 345 x 310 x 495mm
nett Weight: ................................................................8.64Kg ..............................................12.36Kg .......................................... 18.40Kg
T
hickness Wall/Door:
..................................................
2/4mm
................................................
2/4mm
.............................................
2/4mm
4. iNStaLLatioN
4.1.
Careful consideration should be given to the sighting of the safe
to ensure that it is discreetly placed and not easily found by any
intruders.
4.2.
Each safe is supplied with four anchor bolts suitable for fixing to
brick and concrete.
4.3.
Fixing to hollow partition walls is not recommended. If fixed to
wood it must be to a solid wooden structure.
4.4.
Open the door of the safe and with the help of a second person,
position it where required and mark the mounting positions
through the pre-drilled holes in either the back or the base of
the safe.
4.5.
Drill four 10mm holes to a depth of 38mm and insert the four
anchor bolts with nuts and washers removed. (fig.1.1&2)
4.6.
Position the safe over the four protruding mounting studs and
support it there whilst placing a washer, split washer and nut
onto each stud. (fig.1.3)
4.7.
Continue to support the safe whilst tightening the fixings using
a 10mm spanner. (fig.1.4)
SKS01
SKS02
SKS04
fig.1
S
KS01 SKS02 SKS04 Issue 3 (HF) 21/12/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
