instructions for
vacuum fuel/fluid extractor 8ltr
model no:
tP204
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. Safety
WarNiNG!
ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
equipment.
9
f
amiliarise yourself with the extractors application and limitations, as well as the specific potential hazards peculiar to this product.
9
maintain the extractor in good condition.
9
replace or repair damaged parts. use genuine parts only. non authorised parts will invalidate the warranty.
9
Use only to extract engine/transmission oils, fuels or similar NON-Corrosive fluids. Unit may also be used for the transfer of water.
9
ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
dispose of waste liquids in accordance with local authority regulations.
8
do Not
store fluids in the container. Once used to extract fluid, it must be emptied into an approved receptacle as soon as possible.
8
do Not
dismantle, tamper or adapt the extractor for any purpose other than for which it is designed.
8
do Not
use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
do Not
use to store any fluids, ensure unit is cleaned after every use, especially when fuel has passed through the pump. Wash
through with a mild detergent and water by drawing the detergent through the pump to remove all pumped liquid.
Keep the extractor clean and store in a safe dry location.
do Not
store in areas of high temperature, direct sunlight, rain or snow.
2. iNtroductioN
8Ltr Capacity device constructed from composite materials. Suitable for the extraction of all types of engine, transmission and lubricating oils
from vehicles and machinery. Also suitable for the extraction of petrol/diesel and low viscosity fluids such as water. Supplied with 1.5mtr. main
hose with interchangeable
Ø
6.7mm dipstick oil probe and
Ø
7mm universal fluid probe. Supplied with fuel system adaptor (FSA) for use in
conjunction with fuel kit Model No’s VS552, VS553, VS554 and VS555. Can also be used for draining fish tanks, basins and sinks.
3. SPecificatioN
model no: .....................................................................
TP204
capacity: ..........................................................................8ltr
d
ipstick Probe:
..................................................
Ø
6.7x700mm
u
niversal Probe:
..................................................
Ø
7x400mm
fsA Pipe: ...................................................................
240mm
t
P204 | Issue 1 11/07/16
Original Language Version
© Jack sealey limited
refer to
instructions
fig.1
Wear Eye
Protection
Wear Protective
Gloves
Wear Safety
footwear
Wear Protective
clothing
