background image

 

 

 
 
 

 

 
 
 
 

 

 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 

 
 

INSTALLATION INSTRUCTIONS: 

 
The  SV-6940.LM.II  universal  lip-mount  waterproof  back-up  camera  is  designed  to  be  installed 
on any vehicles.  Most installations  are easy to  install  with no  drilling  required, requiring  minimal 
installation  time.  
This uniquely designed product can be of use for any passenger car, SUV and Van, also can be 
of use for large truck, school bus, bus and boat as well. Furthermore, it can not only be  installed 
on the  license plate  bezel or  trunk lid,  but anywhere on the vehicle, such as under the bumper, 
on the sides of cargo trailers or above the hatch. 

 
FEATURES: 

 

  New and Improved design 

  Enhance the look of your Car, SUV, Truck or Van. 

  The  160

°

  wide-angle  CMOS  color  camera  provides  rear  images  in  real  time  and 

eliminates the dangerous “blind-spot” directly behind your vehicle when backing. 

  Normal or Reverse Image (Selectable) 

  Parking lines help accurately judge distance behind vehicle  

  Easily  connects  with  other  SecurView  monitor  or  aftermarket  monitor  that  uses  an  RCA 

input  

  Easily  connects  with  other  SecurView  products  such  as  any  of  the  LCD  monitors.  It  can 

also be integrated with your existing OEM or aftermarket LCD/TFT displays. 

  Waterproof Design (IP68) 

 

 

 

 

Summary of Contents for SV-6940.LM.II

Page 1: ... vehicle such as under the bumper on the sides of cargo trailers or above the hatch FEATURES New and Improved design Enhance the look of your Car SUV Truck or Van The 160 wide angle CMOS color camera provides rear images in real time and eliminates the dangerous blind spot directly behind your vehicle when backing Normal or Reverse Image Selectable Parking lines help accurately judge distance behi...

Page 2: ... sure there is nothing behind the drilling surface that can be damaged 4 Secure the camera into place using screws or double sided tape If using double side tape make sure the surface is very clean before applying the tape 5 Once the camera is mounting secure the video power cable with zip ties or tape to ensure that it does not move around freely License Plate CameraLens Mounting Surface Cable Mo...

Page 3: ... the reverse lights You may also connect power inside the vehicle under the dash or in the trunk The RED power wire goes to Reverse Light 12V and the BLACK wire to Ground 4 Run the YELLOW RCA video cable to your monitor s video input or reverse camera input 5 There are two small sets of GREEN and WHITE wires that come out of the main camera harness Connect the GREEN wires together to deactivate th...

Page 4: ...f the vehicle license may or may not be necessary It is the sole responsibility of the vehicle owner to check and verify any and all State or Federal Motor vehicle codes with regards to modifications of vehicle license plates The manufacturer of the Securview assumes no liability or responsibility whatsoever with regards modifications of the license plate www crimestopper com email crimestopper co...

Reviews: