background image

Large end of pan connector 
can be trimmed to suit setout.

Threaded 
section can be 
trimmed to 
required size.

Please note

 

Installation shall be in accordance with AS/NZS3500.

 

All measurements are in millimetres. Height dimensions 
are to base of pan. Make allowance for bedding.  

 

Bedding: Pan may be bedded with cement base or using 
silicone sealant. Fix pan to floor using a sand cement 
mixture of 3:1 to a depth of 60mm. Do not use lime or 
fast-drying cement.  

seima.com.au

 

Bracket fixing: The pan should be bedded with silicone 
sealant and fixed with the brackets supplied. 

 

Do NOT use epoxy type adhesives.

 

Dimensions are nominal and subject to normal ceramic 
manufacturing variations. 

 

Specifications may vary without notice as part of our 
continuous improvement practices.

 

Clean with a damp cloth. Do not use abrasive cleaners, 
liquids or pastes.

CISTERN PACKAGE CONTENTS

1 x ceramic cistern lid 
1 x ceramic cistern base

Cistern is supplied with flush 
valve and dual purpose inlet 
valve already installed.

PAN PACKAGE CONTENTS

1 x ceramic pan

1 x pan connector

For connecting pan to 
floor outlet pipe/S-trap.

1 x threaded section  
(with flange plate)

Flange attaches to wall; 
threaded section links to 
pan connector.

2 x concealed 
fixing brackets

Optional — can be 
used to connect 
pan to floor.

2 x floor bolts  
(+ white plugs)
2 x washers

Optional fixing #2 — 
used with fixing brackets 
to secure pan to floor.  
Bolt is inserted through 
bracket base hole.

2 x caps (chrome plated)
2 x screws
2 x pan plugs (white)

Optional fixing #2 — used to 
secure pan to concealed fixing 
bracket.  Plastic plug is placed 
into hole in side of pan exterior, 
screw is rebated into plug 
and then screws into a hole 
in upright section of bracket.  
Chrome cap is used to cover 
plastic plug.

IMPORTANT

1  Inspect the components before installation to ensure there are no visible 

defects. If a defect is found, do not install the toilet suite and contact the 
supplier immediately. Claims for defects will not be accepted after the product 
has been installed.

2  This toilet suite is suitable for a variety of set-ups:

 

Cistern — accommodates either Back Entry Inlet connection or Bottom Entry 
Inlet connection (left or right stop valve).

 

Pan — universal trap — accommodates S-trap installation or P-trap installation 
(using appropriate connector; not supplied).

3  The toilet suite must be installed by a licensed plumber. Failure to do so may 

void the warranty.

4  Installation must be in accordance with AS/NZS3500.

2 x bolts w seals

For attaching 
cistern to pan.

2 x plugs

Plugs can be used to 
plug holes in sides of 
pan if required.

1 x rubber seal

For sealing outlet at  
base of cistern.

1 x flush button

Half flush left, full 
flush right.

Note: The cistern can 
be adapted for bottom 
entry plumbing. The 
bottom entry inlet 
valve shown above is 
an optional extra.

OPTIONAL EXTRA

bottom entry 

inlet valve

Installation Guide

Limni Wall Faced Toilet Suite

limni-wf-in | v 3.0  |  page 1 of 4   

Reviews: