STREET RAMP L1 and L2 EXTENSION
DESIGNED FOR BIKES - SKATEBOARDS – SCOOTERS
The New Sender Street Ramp L1 has 3 Curved take off heights of 200 mm 350 mm and 500 mm. The L2 Extension
(Additional Product) bolts to the L1 to create a ramp 750 mm high! The L3 (available soon) will be 1000 mm! Sender
Street Ramp L1 is super compact when folded at just
600 mm x 410 mm x 190 mm. The ramp is made from super
strong 18 mm Birch Plywood and only weighs 18 kgs. Once attached the L2 makes the Ramp 29 kgs. The L1 ramp can
be turned into a rucksack to carry to the park with simple straps. Parents and Guardians of young children should
assess the child’s ability to carry this ramp safely to its point of use. A Strong Vinyl bag is available for the L1 and L2 if
you prefer a better carrying solution. The L2 should not be attached to the L1 and used in rucksack mode with the
straps alone.
The ramp can be assembled for use in less than 1 minute. There are no screws. The structure pushes together and
each section is held with a super strong strap. The 200 and 350 Section are held with heavy duty clips. Placing the
ramp into 500 mm High mode requires legs to be attached with 6 x M10 Bolts. These are inside the small cotton bag
with a 6 mm hex key. You will also find a Hex key on most Portable Bike Tools if you lose the supplied Hex key.
The ramp is coloured with an exterior grade preservative. It is important to coat all other edges and faces with a
clear wood preservative if you would like the ramp to last and function properly. Maintaining your product will
greatly increase its life span. We recommend treating your ramp annually and spraying bolts and T nuts regularly.
Always bring your ramp inside to dry after use. Wood can swell and jam. Some components have small tolerances to
ensure a strong stable structure.
Never drag your ramp around. Lift and place the ramp where you will jump to avoid damage to ground contact
points. You can use the ramp on all surfaces as long as it is flat and even and the sides / feet do not sink.
ALWAYS CHECK YOUR RAMP IS PROPERLY ASSEMBLED BEFORE EACH TAKE OFF
Jumping can go wrong very quickly and lead to severe or even life changing injuries and damage to you bike,
skateboard, scooter and property. We recommend grass take offs and landing when using a bike. Always wear a
helmet, knee pads and gloves as a minimum. Ensure clear take-off and landing space all around and if used on the
street locate and jump in a safe place with no chance of striking or being struck by a car, van etc.