Installation and Startup Guide
This document covers the installation of
VISUAL 7N
HMI, for the detailed specifications and
operation, please refer to Brochure and EasyBuilder Pro User Manual.
Install Environment:
NEMA Rating
VISUAL 7N
HMI is NEMA 4 rated (Indoor Only).
Electrical
Environment
VISUAL 7N
has been tested to conform to European CE requirements.
This means that the circuitry is designed to resist the effects of electrical noise.
This does not guarantee noise immunity in severe cases. Proper wire routing and
grounding will insure proper operation.
Environmental
Considerations
(1)
Make sure that the displays are installed correctly and that the operating
limits are followed. Avoid installing units in environments where severe
mechanical vibration or shocks are present.
(2)
Do not operate the unit in areas subject to explosion hazards due to
flammable gases, vapors or dusts.
(3)
Do not install the unit where acid gas, such as SO2 exists.
(4)
This device should be mounted in the vertical position and for use on the flat
surface enclosure.
(5)
Conform to UL508 (ISBN 0-7629-0404-6) machine safety for use in
Pollution Degree 2 Environment.
Unpacking the Unit
Unpack and check the delivery. If damage is found, notify the supplier.
NOTE: Place the operator panel on a stable surface during installation. Dropping it or letting it fall
may cause damage.
(1)
Installation Instruction, 2-sided A4 *1
(2)
Human Machine Interface *1
(3)
Power Connector *1
(4)
Brackets & Screws *1 pack
(5)
Fuse 1.6A/250V 5*20mm *1
Installation Instructions
Secure the operator panel in position, using all the fastening holes and the provided brackets
and screws. Screw Torque: 2.6 ~ 3.9 lbf.in. (For reaching waterproof effect and preventing the panel from
being deformed.)
Type
A(mm)
B(mm)
VISUAL 7N
260
202
Power Connections
NOTE:
1. Connect positive DC line to the ‘+’ terminal and the
DC ground to the ‘-’ terminal.
2. When downloading project using a USB cable, do
not connect HMI with PLC and PC simultaneously, for
electric potential difference may result in damage to
HMI or PC.
System Settings
When HMI is powered up and displays image,
click the system setting button.
(Default System Password: 111111)
It is necessary
to connect the HMI to
your network through a RJ-45 cable.
VISUAL 7N
Installation Instruction
1
2
3
5
4
(A)
(B)
Cutout
Go to the Network tab, you may choose
to auto get DHCP IP, or designate your
own IP.
(1)
(2)
(5)
(4)
(3)
MI005
07
0-E
