background image

 

 

 

Wishing Well Water Feature Instruction Manual 

G1391 

Safety Warnings and General Information: 

 

Use this product only in accordance with the instructions. 

 

Children should be supervised to ensure that they do not play with product.  

 

This product is not a toy.  

 

Keep the product and its power cable out of reach of children.  

 

Before cleaning and when not in use unplug from the mains supply.  

 

Do not handle the electrical components with wet hands.  

 

Do not use the appliance with a damaged power cord or plug.  

 

To avoid hazards, ensure that any electric cable is safely out of the way of children and 
pets.  

 

Where possible ensure all power cables are positioned away from footfall areas.  

 

It is important that an RCD (Residual Current Device) is present and any product of this 
type is connected to it.  

 

When removing re-positioning or replacing the water pump make sure the power is off 
and the plug is out of the socket.  

 

Repairs to electrical equipment should only be performed by a qualified electrician. 
Improper repairs may place user at serious risk.  

 

Always use the original power cable supplied with the product.  

 

Make sure the voltage on the rating label matches the mains power supply to be used.  

 

Do not unplug by pulling the power cable.  

 

Water temperature must not exceed 35°C. Top the water levels up frequently during hot 
weather.  

 

In very low temperatures, drain, dry and protect the water feature from frost, snow and 
ice. 

 

This product is designed for outdoor use only and should not be positioned where water 
spillage may damage carpets or furnishings. 

 

Always position on a flat level surface. 

 

The chosen location should be free from overhanging trees and bushes which may shed 
their leaves in autumn. 

 

Ensure that the water level is always sufficient; do not allow the pump to run dry. 

 

To eliminate the possibility of water damage around your water feature, check for leaks 
and excessive splashing after the initial setup. 

 

Do not leave your water feature running for extended periods of time unattended. 

 

Occasionally the water pump may make excessive noise, this may be due to the pump 
rattling against the side of the reservoir or a small amount of trapped air.  Always ensure 
that the pump is suckered to the base using the rubber feet.  Remove any trapped air by 
gently shaking the water pump. 

 

This water feature is not suitable for commercial purposes. 

Reviews: