background image

1

INSTALLATION MANUAL

 SPECIAL WARNING

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL 

INSPECTOR’S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

 CLEARANCES AND DIMENSIONS

For SAFETY CONSIDERATIONS do not install drawer in any combustible cabinetry, which is not in 

accord with the stated clearances and dimensions on pages 2 and 3. See Figures 1 and 2.

UNPACKING YOUR MICROWAVE DRAWER ...................2

IMPORTANT NOTES .............................................2

IMPORTANT SAFETY INSTRUCTIONS .........................2

CLEARANCES AND DIMENSIONS ..............................2

MICROWAVE DRAWER MEASUREMENTS ....................3

ANTI-TIP BLOCK ................................................3

ELECTRICAL OUTLET ...........................................4

GROUNDING INSTRUCTIONS ...................................4

DRAWER INSTALLATION .......................................4

MODEL AND SERIAL NUMBER LOCATION ....................4

CARE, CLEANING AND MAINTENANCE  ......................4

M

ICROW

AVE

 D

RA

WER

Microwave Drawer

Microwave Drawer

Summary of Contents for Inside Pro

Page 1: ...t install drawer in any combustible cabinetry which is not in accord with the stated clearances and dimensions on pages 2 and 3 See Figures 1 and 2 UNPACKING YOUR MICROWAVE DRAWER 2 IMPORTANT NOTES 2 IMPORTANT SAFETY INSTRUCTIONS 2 CLEARANCES AND DIMENSIONS 2 MICROWAVE DRAWER MEASUREMENTS 3 ANTI TIP BLOCK 3 ELECTRICAL OUTLET 4 GROUNDING INSTRUCTIONS 4 DRAWER INSTALLATION 4 MODEL AND SERIAL NUMBER ...

Page 2: ...alled Anti Tip block This Microwave Drawer must be electrically grounded in accordance with local codes Make sure the wall coverings and the cabinets around the Microwave Drawer can withstand the heat generated by the Microwave Drawer Never leave children alone or unattended in the area where a Microwave Drawer is in use Never leave the drawer open when the microwave is unattended Stepping leaning...

Page 3: ...LLATION MANUAL Figure 2 Figure 1 Figures 1 and 2 contain many Microwave Drawer measurements for reference when planning the drawerʼs location MICROWAVE DRAWER MEASUREMENTS ANTI TIP BLOCK 5 2x4 Anti Tip block 6 Figure 4 Figure 3 NORMAL INSTALLATION STEPS ANTI TIP BLOCK INSTALLATION INSTRUCTIONS To reduce the risk of tipping of the drawer the Anti Tip block must be properly installed located 14 3 4 ...

Page 4: ...awer with the 4 screws supplied See Figure 6 Figure 6 ELECTRICAL OUTLET 4 5 electrical outlet location 2x4 Anti Tip block 6 The electrical requirements are a 120 volt 60 Hz AC only 15 amp or more protected electrical supply It is recommended that a separate circuit serving only this appliance be provided The drawer is equipped with a 3 prong grounding plug It must be plugged into a wall receptacle...

Reviews: