1
Dishwasher: SDW6747GS
INSTALLATION MANUAL
BEFORE YOU BEGIN READ THESE
INSTRUCTIONS COMPLETELY AND
CAREFULLY.
IMPORTANT – Observe all governing codes and ordinances.
1
Note to Installer – Be sure to leave these instructions for the
consumer’s and local inspector’s use.
2
Note to Consumer – Keep these instructions with your Owner’s
Manual for future reference.
3
Skill Level – Installation of this dishwasher requires basic
mechanical and electrical skills. Proper installation is the
responsibility of the installer. Product failure due to improper
installation is not covered under the SHARP Consumer Limited
Warranty.
4
Completion Time – 1 to 3 Hours. New installations require more
time than replacement installations.
IMPORTANT
– The dishwasher MUST be installed to allow for
future removal from the enclosure if service is required.
If you received a damaged dishwasher, you should immediately
contact your dealer or builder.
FOR YOUR SAFETY
- Read and observe all CAUTIONS
and WARNINGS shown throughout these instructions. While
performing installations described in this booklet, gloves, safety
glasses or goggles should be worn.
WARNING
To reduce the risk of electric shock, fire, or injury to
persons, the installer must ensure that the dishwasher
is completely enclosed at the time of installation.
READ CAREFULLY.
SAVE THESE INSTRUCTIONS.
If you have an installation problem, contact your dealer or installer.
You are responsible for providing adequate electrical, exhausting
and other connecting facilities.
1
INSTALLATION PREPARATION
PARTS SUPPLIED:
NAME & DESCRIPTIONS
QTY.
PARTS
Flat Head Wood Screws to secure
dishwasher to underside of
countertop (in literature package)
4
Screw Type Hose Clamps
1
Drain Hose
1
Top Mounting Clips
2
MATERIALS REQUIRED:
NAME & DESCRIPTIONS
QTY.
PARTS
Ferrule, Compression Nut and
90° Elbow (
3
/
8
" NPT external
thread on one end, opposite end
sized to fit water supply)
1
Thread Seal Tape
1
UL Listed Wire Nuts
3
