Sharper Image
®
name and logo are registered trademarks. Distributed by
and © 2022 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
Distributed by MerchSource, LLC, Irvine, CA 92618.
For technical support, please visit www.merchsource.com or call
1-800-374-2744.
The artwork and design of this manual are protected by US copyright law
and may not be reproduced, distributed, displayed, published or used for
any purpose without prior written permission. It is not permitted to alter,
remove or reproduce any trademarks or copyright notice from this manual.
Printed in China.
Drone Air Racer
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the picture on the manual may
differ slightly from the actual product.
PATENT PENDING
CUSTOMER SUPPORT
(800) 374-2744
Before calling please locate the 10-digit
code printed on the back of your remote
QUESTIONS OR CONCERNS?
PLEASE GIVE US A CALL ... WE’RE HERE TO HELP
1. PREPARE FOR FLIGHT
• Drone must be charged before each use (Cable included)
.
• Indicator light will turn off once fully charged.
• Install batteries in remote.
2. PAIR YOUR DRONE
Before each flight pair the remote with the drone:
• Turn your drone on and place on a flat, level surface.
• Turn on the remote on and move the left joystick up, then down.
• The beep will indicate successful pairing.
• Repeat steps 1 and 2 if necessary.
3. REMOTE CONTROL OVERVIEW
Practice flying your drone below 10 feet and at low speeds until comfortable with all controls to
avoid unnecessary damage or injury.
• Left joystick: left/right controls spin and Up/Down controls elevation.
• Right joystick: controls flight direction.
• Direction Trim: use to eliminate drift.
To cut power to drone, move left joystick to down position.
Getting to Know Your Drone
PLEASE READ ALL WARNINGS AND
INSTRUCTIONS PRIOR TO USE. KEEP THIS
DOCUMENT AS IT CONTAINS IMPORTANT
INFORMATION ABOUT YOUR DRONE.
14+
ADULT ASSEMBLY, CHARGING, AND
BATTERY INSTALLATION IS REQUIRED.
ADULT SUPERVISION IS REQUIRED.
