Introduction
Your new Model W1800 Spray Gun Holder (
Figure 1
) is
designed to hold a spray gun and a paint filter.
Inventory
(Figure 1)
Qty
A.
Spray Gun Holder Base ...................................1
B.
Filter Holder ................................................1
Figure 1.
Model W1800 inventory.
A
B
COPYRIGHT © JUNE, 2007 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
#9573BL
Model W1800
Spray Gun Holder
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
Figure 2
. Model W1800 setup to filter
paint.
Holder
Filter
Mounting
Holes
Base
FIRE HAZARD! Mount the spray gun holder in a
location away from potential ignition sources. Many
paints and liquids are flammable. Ignoring this
warning may lead to serious personal injury.
Workbench Mounting
Attach the spray gun holder base to a workbench using
two #12 tap screws (not included).
Note:
Consider mounting the base to the front of a work-
bench with the rings facing out for convenience. This also
ensures that a spray gun equipped with a pressure gauge
or adapter will not hit the bench when mounted on the
holder, as shown in
Figure 2
.
Wall Mounting
Mount the spray gun holder base to a wall with drywall
anchors or fasten it to a board attached to studs using #12
tap screws.
Holder Assembly & Operation
1.
Assemble the base and holder, then position the spray
gun and filter (not included), as shown in
Figure 2.
2.
Pour paint into the filter; it should flow into the feed
cup.
