Model W1734
Downdraft Sanding Table
Introduction
The Model W1734 is intended for use with a dust
collection system or a Shop Vac
®
-style vacuum
with at least a 2
1
⁄
2
" inlet size. Note—
Inlet sizes
smaller than this will not allow the Model
W1734 to work as designed.
Specifications
• Table Size ..............................15" x 25"
• Dust Port Size .............................. 2
1
⁄
2
"
• Minimum Dust Collector Inlet Size ...... 2
1
⁄
2
"
• Overall Size ...............15" D x 25" L x 5" H
• Weight ......................................8 LBS
Connection
Connect your downdraft sanding table to your
dust collection system or Shop Vac
®
-style vac-
uum with a 2
1
⁄
2
" dust hose and hose clamp, as
shown in
Figure 2
.
Operation
To use the downdraft table, simply start your
dust collector or Shop-Vac
®
-style vacuum and
sand your workpiece on the table, as shown in
Figure 3
.
Cleaning
Your table surface may be cleaned with a damp
rag. If your table surface gets gummy from wood
pitch, you can use a non-corrosive blade cleaner
like Oxisolv
®
to easily remove it without harming
the tabletop surface. DO NOT clean with prod-
ucts that will harm the paint on the table surface
like brake parts cleaner, acetone, or gasoline.
Customer Service
For questions contact Woodstock International
Technical Support at (360) 734-3482, or send e-mail
to: tech-support@shopfox.biz.
Figure 1.
Model W1734.
Figure 2.
Dust port connected to dust
collection system.
Figure 3.
Sanding on the downdraft table.
COPYRIGHT © MAY, 2004. BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
#6297TR. REVISED OCTOBER, 2004. PRINTED IN CHINA.
