background image

VALLONA RANGE HOOD INSTALLATION

IMPORTANT SAFETY INFORMATION

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR 
PERSONAL INJURY, PLEASE READ THE FOLLOWING:

Use the range hood only in the manner intended by the 
manufacturer. If you have questions, please contact Signa-
ture Hardware Customer Relations at 866-855-2284. 

Before servicing or cleaning the unit, power off the unit and 
switch off the unit’s circuit on the electrical panel. 

Installation and electrical wiring must be done by a qualified 

and licensed professional in accordance with all applicable 

codes, standards, and fire-rated constructions. 

Do not use the unit if any fans or electrical wiring are 

damaged. Contact Customer Relations or a qualified 

professional if any such issues arise. 

To prevent backdraft, sufficient air is needed for proper 

combustion. Gas from the fuel burning equipment needs to 

exhaust through the flue (chimney). Follow the heating 
equipment manufacturer’s guidelines and safety standards 
such as those published by the National Fire Protection 
Association (NFPA), the American Society for Heating, 
Refrigeration and Air Conditioning Engineers (ASHRAE), and 

the local code authorities. 

When cutting or drilling into walls or the ceiling, be aware of 
electrical wires, plumbing, and other utilities behind the wall. 

Ducted fans must always be vented outdoors.

CAUTION: 

For general ventilation use only. Do not use to 

exhaust hazardous or explosive materials and vapors.

CAUTION: 

To reduce the risk of fire and to properly 

exhaust air, be sure to duct air outside - DO NOT vent 
exhaust air into attics, crawl spaces, garages, or within walls 
or ceilings.  

1

Vallona Range Hood Installation Instructions

TO REDUCE THE RISK OF A STOVETOP GREASE FIRE, 
PLEASE READ THE FOLLOWING:

Never leave surface units unattended at high settings. 
Boil-over can cause smoke and grease to spill over which 
could ignite. Heat oils slowly on low or medium settings.

Always turn the range hood ON when cooking at high heat or 

when cooking foods that could flame. 

Clean venitlation fans frequently. Grease should not be 

allowed to accumulate on fans or filters.

Use proper pan sizes when cooking. Always use cookware 
appropriate for the size of the surface element.

TO REDUCE THE RISK OF INJURY, IN THE EVENT OF A 
STOVETOP GREASE FIRE, PLEASE READ THE FOLLOW-
ING:

SMOTHER FLAMES with a close-fitting lid, cookie sheet, or 
metal tray, then turn off the burner. BE CAREFUL TO 
PREVENT BURNS. If the flames do not go out immediately, 
EVACUATE AND CALL THE FIRE DEPARTMENT. 

Never pick up or handle a flaming pan.

DO NOT USE WATER, including wet dishcloths or towels. 
This could cause a violent steam explosion. 

Use an extinguisher ONLY if:

- Your fire extinguisher is a class ABC extinguisher, and you 

know how to operate it.

- The fire is small and contained in the area in which it 

started.

- The fire department has been called.
- You can fight the fire with your back to an exit.
   *Above based on “Kitchen Fire Safety Tips” published by the 
NFPA.

TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, 
DO NOT USE RANGE HOOD WITH ANY SOLID-STATE 
SPEED CONTROL DEVICE.

Summary of Contents for VALLONA








Reviews: