1
Victorian Door Knob & Plate Set Installation Instructions
VICTORIAN DOOR KNOB AND PLATE SET
INSTALLATION INSTRUCTIONS
Before you begin, read the installation instructions below. Observe all local building and safety codes. For the following
installation instructions it is assumed that holes for the handle and lock set are pre-drilled.
Unpack and inspect the product for any shipping damages and ensure that none of the required pieces are missing. If
you find damages, do not install. Contact Customer Service at 1.866.855.2284. If you need assistance or have questions
while installing your door handle and plate set, contact Customer Service.
We recommend consulting a professional if you are unfamiliar with installing hardware fixtures. Signature Hardware
accepts no liability for any damage to the handle, lock set, or door, or for personal injury during installation.
TOOLS AND MATERIALS:
Pencil
Screwdriver
Wood Chisel
Drill
DUMMY SET INSTALLATION
1. Remove the set screws on the door knobs (
B
) with the
Allen wrench provided (
C
) to disconnect the knobs.
2. Position the dummy spindle (E) in the desired
mounting location.
3. Mark the mounting hole locations on the door.
4. Drill pilot holes with the appropriate drill bit for your
installation.
5. Secure the spindle to the door with the provided wood
screws (D).
6. Thread the decorative escutcheon (A) onto the
dummy spindle. Secure to the door with screws.
7. Thread the door knob (B) onto the dummy spindle.
8. Place a set screw in the set screw hole on the side
of the door knob. Use the provided Allen wrench (C) to
secure.
A
B
C
D
E