Page 1 of 5
"Telecommunication Products to solve Telecommunication Problems"
CK-1P7
Promotion-On-Hold
Module
For use with the KX-TG4500, KX-
TG4000 & KX-TG2000 Phones
For
S/N
B4020001 and above
Introduction
Thank you for purchasing the Skutch CK-1P7 Promotion-On-Hold Adapter for the
Panasonic KX-TG4500, KX-TG4000 four line, and KX-TG2000 two line cordless phone
systems. The CK-1P7 is a true plug and play device. The unit does not require any
"Learning" to operate. When a call is placed ON HOLD from any cordless phone or the
base station, the ON HOLD caller will hear the Promotion-On-Hold audio. When the line
is re-answered, the audio automatically stops. It's that simple!
NOTE #1
: If you are installing the CK1P7 on a two line KX-TG2000, see the "KX-
TG2000 Installation Notes" on page 3 before starting.
NOTE #2:
If you transfer a call to a Voice Mail Box after a call has been answered by
a live person, Promotion-On-Hold will play over the message.
Installation
1- Position the CK-1P7 box under the base telephone with the jacks facing towards the
back of the phone. (See Fig. 3).
2- Make sure that the surface on the telephone is clean and free of dust and/or oil.
3- Peel the paper protector off back side of the "SENSOR BOARD" . Carefully align as
shown in Fig. 2. The Sensor Board has been designed to fit the contour of the phone, and
should lock into place. Press down on the Sensor Board to make sure it sticks well.
Audio Cable
Sensor Board
Power Cube
CK1P7 Box
with Adapter
