Installation Instructions for the
Skuttle Make-Up Air Diffuser
Model No. D-28-6
READ AND SAVE THESE INSTRUCTIONS
The
Skuttle Make-Up Air Diffuser
allows clean, fresh
air to enter your home whenever there is a negative
air pressure buildup or a need for replacement (make-
up) air.
NOTE:
The Diffuser may be attached directly to the
furnace cabinet. It may also be installed on a nearby
wall or substantial support structure, but
must be in-
stalled within 1 ft. (30.48 cm) of the furnace cabi-
net
. (See diagram above.)
CAUTION:
Be sure to follow all local codes and or-
dinances.
INSTALLATION INSTRUCTIONS
Mount the Diffuser in a vertical position with the #8
sheet metal screws provided.
DANGER:
Do not drill into electrical wiring or re-
frigeration lines during installation.
Select a location for the outside air intake vent. Cut
the outside opening to allow room for a 6 in. (15.24
cm) diameter duct to be installed.
CAUTION:
To prevent contaminated air from en-
tering the inlet, make sure the Diffuser is at least
10 ft. (3.05 m) from any discharge source
1.
2.
(e.g., an exhaust vent, sewer vent, dryer vent or
combustion outlet.
Install the 6 in. (15.24 cm) flexible duct (not sup
-
plied) between the Diffuser and the inlet hood.
NOTE:
Flexible duct tubing is not supplied be-
cause lengths vary greatly from home to home.
Tape and seal all joints. Insulate the tubing in ar-
eas where outdoor winter temperatures drop to
32°F (0°C) or lower, or where water damage could
occur.
CAUTION:
In homes with extreme negative pres-
sures, the influx of cold outdoor air into the Diffuser
may reduce temperatures in the surrounding area,
possibly resulting in freezing conditions. In cold re-
gions where this could occur,
insulate plumbing
or supply additional heat to the area
.
3.
4.
SIZE: 19-1/4 in. (48.90 cm) H x 9-1/2 in. (24.13 cm) W x 9-1/2 in. (24.13 cm) D
Phone: 888-SKUTTLE (758-8853) or 740-373-9169
Email: techservice@skuttle.com
© Skuttle Mfg. Co., 2008 • WEB-0756-251 • 4/08
