FLYING GUIDE
STREAMING DRONE WITH AUTO PILOT
v2450GPS
CONNECTING DRONE TO SMART PHONE
ACQUIRING GPS LOCK
When enough satellites are locked
on, the GPS MODE will illuminate a
solid GREEN. The frame is now
ready to fly in GPS mode.
Raise the throttle stick to arm the
frame. The motors will spin, indicating
the frame is armed. Increase throttle
to lift off of the ground.
When flying in GPS mode, press the
RETURN button to RETURN HOME.
The frame will fly back to the home
location and land.
RETURN HOME will
ONLY work if GPS MODE is active.
Press RETURN a second time to
CANCEL the RETURN HOME action.
Press RETURN a second time to CANCEL the LAND action.
The frame will start to acquire
GPS satellites. During this time,
the GPS MODE LED will blink.
If GPS mode is taking too long to lock, you can still launch the frame while the system continues to lock. Simply raise the
throttle stick while the device continues to lock on to the GPS signal. Indoor LED will blink while you are flying without GPS
lock, and will turn off once GPS lock is established.
CAUTION: In this case, your HOME LOCATION will start
where the GPS MODE is obtained. This may not be near your launch location.
If an open sky is not possible, the frame can be flown in INDOOR mode.
To activate this mode, a tap of the MODE button will enable INDOOR MODE.
The INDOOR LED will illuminate solid red to indicate this mode is active.
1. Go to the Wi-Fi settings on your device and select SKYVIPERGPS_XXXXXX to connect.
(Name of Sky Viper network may vary). Connection may take up to 30 seconds.
2.
Enter the Wi-Fi password: vipergps
3. Open the
Sky Viper Video Viewer
App on your device
• HOME LOCATION starts where GPS lock is first
obtained, or can be updated from the app to your
current location.
• While the drone is RETURNING TO HOME, you
will still have altitude and directional control to
avoid obstacles.
• While the drone is LANDING, you will still have
directional control to control your exact landing
location.
• Press RETURN a second time to cancel the
RETURN TO HOME or LAND action.
WARNING: GPS MODE SHOULD ONLY BE USED OUTDOORS
INDOOR MODE
RETURN TO HOME / LAND
ATTACH YOUR PHONE TO THE REMOTE
If not already assembled, attach
phone mount to remote.
Push upper lip of phone mount
upward and insert your phone into
mount as shown.
v2450
GPS
Dowload and install free
Sky Viper Video Viewer
app onto your smart phone.
INSTALL THE SKY VIPER VIEWER APP
Raise the throttle stick to arm the
frame. The motors will spin, indicating
the frame is armed. Increase throttle
to lift off of the ground.
When flying in INDOOR mode, the RETURN button will
cause the drone to LAND at its current location.
with an unobstructed view to the sky
POWERING UP AND PAIRING DRONE TO REMOTE
Charge LiPo battery and insert into drone. Install 3 fresh 1.5V AA (LR6) batteries into remote.
