Skyrack Canada • (514) 503-‐2311• info@skyrack.ca • www.skyrack.ca
1
INSTRUCTION & ASSEMBLY SHEET
ROBUST SKYRACK J-‐STYLE KAYAK CARRIER
MODEL # SR-‐KR-‐102
PARTS INCLUDED
•
DESCRIPTION
•
QTY.
WARNINGS / LIMITATIONS
1
Long tube
2
•
Load bars must be at least 24” (61 cm) apart for safe use;
•
Do not exceed the factory recommended load on the
crossbars;
•
Maximum kayak load should not exceed 130 lbs (59 kg) on the
Skyrack J-‐style kayak carrier;
•
Ensure the kayak carrier and the crossbars are properly
installed and tightened on the vehicle;
•
The kayak must be centered on the kayak carriers;
•
Always tie down the bow and stern of the kayak to vehicle
bumpers or tow hooks (sold separately);
•
Compatible only with sea kayaks and whitewater kayaks. This
product is not designed for aluminum boats;
•
All bolts, nuts and screw knobs must be checked and
tightened before every use to ensure smooth and safe
operation;
•
Not for off road use;
•
Do not use Robust Skyrack J-‐Style kayak carrier SR-‐KR-‐102 and
accessories for purposes other than those for which they
were designed.
Failure to follow above guidelines voids warranty.
2
Short tube
2
3
Junction tube
4
4
High-‐density foam
8
5
Carrier rubber base
2
6
Carrier steel plate
2
7
Fixation plate
4
8
Screw knob
8
9
Bolt 2’’7/8 (73 mm)
8
10
Flat washer
8
11
Bolt 1’’1/2 (38 mm)
4
12
Nylon lock nut
4
13
Tie down strap 8’ x 1’’ (244 cm x 2.54 cm)
2
TOOL(S) NEEDED
•
13 mm wrench
MOUNTING INSTRUCTIONS
1.
Insert the Carrier steel plate (bump facing up) (#6) inside the Carrier rubber base (#5);
2.
Insert the Junction tube (#3) inside the Long tube (#1) and align the hole;
3.
Insert the Junction tube (#3) through the Carrier rubber base (#5) in the Short tube (#2). Make sure that the Carrier steel plate
(#6) is under the Tubes (#1) and (#2);
4.
Insert the Bolts (#11) in the middle holes of the Carrier rubber base (#5) going through Tubes (#1) and (#2), Junction tube (#3)
and the Carrier steel plate (#6). Lock the Bolt (#11) with the Nylon lock Nut (#12);
5.
Insert the Bolts (#9) in the 4 corner holes of the Carrier rubber base (#5);
6.
Place the rack on the crossbars; insert the Fixation plate (#7) under the crossbars on the bolts (#9), then the Flat washers (#10)
and the Screw knob (#8);
7.
Tighten all Bolts (#9) and (#11), Nylon lock nuts (#12) and Screw knobs (#8);
8.
Check tightness and good condition of each parts every use.
