1
SLA.747 757
B4 Adventure 4040 Holly Street Unit 10
·
Denver Colorado 80216
·
1-844-834-4334
QUESTIONS? www.b4adventure.com
•info@b4Adventure.com
·
DC030116-
INSTRUCTIONS AND SAFETY RULES
Thank you for your purchase of the Slide &
Surf™! This product was designed to provide safe fun when
the instructions and rules are followed. Please read and follow all instructions carefully when setting up
and using the Slide &
Surf™.
WARNING: Adult set up and supervision required. Children must be
instructed on and follow the Instructions and Safety Rules at all times.
WARNING: Failure to read and follow the Instructions and Safety
Rules could lead to serious injury, paralysis or death. Use only as
instructed.
WARNING: Not for adult use. Not for use by children over 12 or under
5 years of age. NOT FOR USE BY ANYONE OVER 5 FEET (1.5 M) TALL OR
WEIGHING OVER 110 POUNDS (50 KG).
1.
SITE SELECTION AND SET-UP
•
Slide &
Surf™ must be properly setup and installed by an adult. ADULT SUPERVISION
REQUIRED AT ALL TIMES.
•
Choose a clear runway for the slide on a flat, healthy lawn surface free of depressions or high
spots. The lawn must be a soft, shock absorbing surface, not a hard packed or high traffic area.
•
Do not use on pavement, sidewalks, patios, driveways or other hard surfaces.
•
Allow a minimum of 10 feet (3 m) additional runway space before the slide.
•
Before set-up, check under and around the slide for sharp objects, rocks, sticks, lawn sprinklers
or other objects that could cause injury to users or damage the slide.
•
Place slide down with inflatable bumper side up. Walk off 10 feet (3 m) away on all sides of the
slide and make sure the 10-foot area on each side is free from concrete, sidewalks, trees, walls,
holes, rocks, garden equipment, fences, pools and other sharp objects that could injure users.
•
Inspect slide for rips, tears or punctures. Do not use a damaged slide.
•
Use repair patches included for small tears and punctures.
•
Connect the two long, inflatable slide bumpers to the splash pool bumper
using the two sets of end snaps and tabs (Fig.1)
•
Inflate the two long slide bumpers and half circle splash pool bumper.
•
Inflate the launch pad. Inflate ALL bumpers and launch pad to moderately Fig. 1
firm-
DO NOT OVER INFLATE OR DAMAGE MAY RESULT.
•
Wet the entire slide before connecting hose to slide. Connect hose to spray section.
Need a pump? SLA.727 Air Pump
Sold Separately-Easy to use.
•
Adjust spray height by using your home faucet/spigot handle. Spray MUST land on the slide
section for proper sliding operation and safety. TIP: Place small towels to align/adjust your spray
Note: Towels under the inflatable bumper only. Do not place under the sliding section.
