1
smarttech.com/kb/170597
1022737 Rev 01
Important
Before you configure your
SMART Board® 8084i-G4
interactive flat panel
You need to set the computer (or Microsoft® Lync® appliance) input’s operating mode to “PC” after
you turn on your SMART Board® 8084i-G4 interactive flat panel for the first time but before you
configure and use the interactive flat panel.
I M P O R T A N T
If you do not complete this procedure, the following could occur:
l
The interactive flat panel might not display the outer edges of the computer’s display.
l
Users might notice higher than normal video display latency.
To set the computer input’s operating mode to “PC”
1.
Turn on the interactive flat panel.
2.
If you’re installing the interactive flat panel as part of a SMART Room System™ for
Microsoft Lync, set the Lync Room Reset option as described in chapter 3 of the
SMART Room System for Microsoft Lync setup and maintenance guide
).
3.
On the remote control, press
INPUT
(a), and then press the red button (b),
which is below the BACK button.
The
Input Label
menu appears.
