2014 Compacta International, Ltd. - Rev.
4/2014
ZBMPlug15
and Smartenit are trademarks of Compacta International, Ltd.
ZigBee is a registered trademark of the ZigBee Alliance
(949) 429-3303
Technical Support
Smartenit.com
Quick Start Guide
-
ZBMPlug15
TM
Model #5010Q
Product Brief
Installation
Set-up
For more information, please visit our Wiki
http://wiki.smartenit.com
ZigBee HA Wireless Metering Smart Plug
The ZBMPlug15 enables remote control and monitoring of lamps and
appliances, making them part of a home automation network.
The smart plug also measures the power delivered. This enables the
intelligent management of lighting and other appliances to maximize
energy conservation while taking advantage of the lowest rates offered by
electric utilities. Use of the ZigBee
®
Home Automation (HA) Profile ensures
compatibility with the emerging standards for smart homes/buildings being
deployed around the world.
1.
Reset to Factory Defaults
• Press and hold the Program Button while plugging the ZBMPlug15
into a 120V* AC receptacle and release after 1-2 seconds.
• The Status LED will blink rapidly indicating the ZBMPlug15 has
been reset and is searching for an open HA network to join.
(*240VAC input is acceptable, but the unit is equipped for North American receptacles)
2. Plug desired lamp or appliance into the Controlled Outlet.
(**Do not exceed 450W of incandescent lighting or 15A of resistive load**)
Controlled
Outlet
Program
Button
Status LED
The ZBMPlug15 must be installed indoors or in a weather proof enclosure
1) Joining the ZBMPlug15 to the Network
•
Open a ZigBee HA router or coordinator to permit joining of your ZBMPlug15 to the network.
•
When the ZBMPlug15 begins to join, the Status LED blinking rate will slow until it finally stops when successfully joined.
•
If the device continues to blink rapidly, ensure that your ZigBee HA router or coordinator is still open for join and posi
-
tion the ZBMPlug15 as close to the router or coordinator as possible to eliminate the possibility for any range issues.
2) Binding the ZBMPlug15 to other devices
(device must already be joined to network)
•
To bind the ZBMPlug15 to a ZigBee HA controller, quickly tap the Program Button once then hold for 3 seconds and
release. The Status LED will blink one short blip. Then press the Program Button on the controller device, such as a
switch, according to the instructions of that device.
•
The duration of binding is determined by the coordinator.
