Page
1
of 5
MESH & SOLID SAFETY COVER
INSTALLATION GUIDE
Congratulations on your purchase of a
Safety Cover from Splash Super Center.
Before you Start
Please fully read these instructions before and during the installation,
to ensure a smooth, quick & proper installation.
The Pool Site
Carefully examine the immediate pool area. The deck width around
the pool needs to be a minimum of 3 feet. The cover itself will over-
lap the pool from waters edge approximately 9”- 18” onto the deck
surface. The spring and strapping will extend another 17” from covers
edge.
Examine the deck surface. Are there any extrusions (obstacles) on the
deck surface that would prevent the cover from laying fl at? Rough cop-
ing ladder sockets, waterspouts, and other items that are not fl ush with
the deck. These surfaces should be padded with carpet, foam or other
similar material which will help to protect the cover from chafi ng.
Tools
You will need the following tools to complete installation.
• Rotary Hammer Drill
• 3/4” Concrete drill bit w/long shaft (diamond tip)
• Lubricant (silicone spray)
• Hammer
• Tape measure
• Chalk and chalk line
Included Safety Cover Hardware
Please examine the following list, and
make sure your safety cover includes
all the needed hardware.
Standard Hardware
Brass anchors
Stainless steel springs
Stainless steel buckles
Steel installation rods
Allen wrench
Spring covers
Tamper
Optional Hardware
Wood deck anchors
Anchor tubes
Short springs
Anchor fl anges
Lawn stakes
Automatic cover pump
Raised Wall Hardware
Eyebolts
Cable
Lag shields
PLEASE READ ALL DIRECTIONS CAREFULLY BEFORE DRILLING ANY HOLES
ACURATE MEASURING WILL ENSURE A PROPERLY INSTALLED COVER
60 Campanelli Dr., Braintree, MA 02184 www.splashsupercenter.com
Questions?
Phone us at 1-877-527-4881
(toll free Monday-Friday 9am-5pm EST)
FAX 1-781-297-2083
or email us at customercare@splashsupercenter.com
