background image

 

( 1 / 4) 

 

 

 

 

 

 

 

 

 

 

 

Instruction Manual 

 
 

Models: 

 

 

version 1.0 since 3 February 2020

 

 

 
 

ATTENTION! 

 

This instruction manual contains important information about the installation and the use of 

the equipment. Please read and follow these instructions carefully. 

 

Always ensure that the power to the equipment is disconnected before opening the 

equipment or commencing any maintenance work. 

 

DST5-RDM_en_manual_M087 

 
 

DST5-RDM DMX Splitter

 

DST5-RDM-3, DST5-RDM-5 

DST5-RDM-C

 

Summary of Contents for DST5-RDM

Page 1: ...information about the installation and the use of the equipment Please read and follow these instructions carefully Always ensure that the power to the equipment is disconnected before opening the equipment or commencing any maintenance work DST5 RDM_en_manual_M087 DST5 RDM DMX Splitter DST5 RDM 3 DST5 RDM 5 DST5 RDM C ...

Page 2: ...Con blue connector Standard supply is UNISCHUKO lead with Neutrik PowerCon Always respect the markup of L and N on connectors for correct wiring of Line and Neutral DMX connection DMX connectors are located on one side of the splitter board These are separated to two groups First group is wired in ratio 1 1 and marked as DMX input and DMX thru This line is not optically isolated and when the devic...

Page 3: ...signal Speed of light on these LEDs also indicates the refresh rate of DMX signal Fast blinking high refresh rate slow blinking slow refresh rate On the front panel of DST5 RDM there are outputs A E which are retransmitting the input to the optically isolated outputs If any of data LEDs is off unplug the signal cable corresponding to this output and check the cable for short circuit between D and ...

Page 4: ...roup s r o Address of producer Rybnicna 36 D SK 83106 Bratislava Slovak Republic Declares that the product Name of product DST5 RDM 5 way DMX RDM splitter Type DST5 RDM Corresponds to the following product specifications Safety EN60065 resp EN 60950 EMC EN55103 1 resp EN55103 2 Bratislava 2 November 2014 Robert Sloboda Copyright 2017 SRS Group s r o Specifications subject to change without notice ...

Reviews: