Tools Required:
Phillips screwdriver
7/16” wrench
drill
3/16” drill bit
Hardware included:
(4) 8-32 x 1/2 bolt
(4) 8-32 nut
(4) 1/4 x 1-1/2 lag screw
(4) washers
Record the key number and serial number from the back of the cabinet.
Keep keys in a secure place away from children.
Do not store this document in the cabinet
Portable Case
40651-1511
8
1
Instructions
GCB-1522
INSTALLATION OF BARREL RESTS
SELECTING A LOCATION
Serial #:
Key #:
WARNING
Tip Over Hazard
A child or adult can tip the cabinet and be killed or
seriously injured.
Failure to secure the cabinet as shown in these
instructions can result in death or serious injury to
children and adults.
Children should not play with or around the
cabinet at any time.
Measure and mark the locations of the barrel rests on the inner sides
of the cabinet using the dimension shown. (See figure 1)
To install the barrel rests to the cabinet, first remove the backing from
the foam rests. For help in doing this, pinch the end of the foam to
help secure the adhesive to the foam.
Attach the barrel rests to the inner sides of the cabinet as shown.
Place the bottom pad (A) in the cabinet. (Figure 1)
Installation of Barrel Rests
16"
CENTERS
CABINET
TOP VIEW
MINIMUM
The cabinet must be mounted to wall studs and the floor. For
optimal safety and security, the cabinet should be installed adjacent
to the side wall of a closet with minimal space on either side of the
cabinet, in an isolated, dry and secure area. The cabinet should be
flat against the wall at the back of the unit, as well as flat on the floor.
Remove the baseboard if necessary.
Figure 1
NOTE: You can store your Key # and your Serial # information on
Stack-On’s SECURE web site – www.stack-on.com under Customer
Service.
Storing your Key # will provide instant access to this important information,
should you ever lose your keys or need the number to order a new set.
Only you will have access to this information.
THE CABINET SHOULD ALWAYS BE KEPT OUT OF
THE REACH OF CHILDREN.
IMPORTANT:
A
38"
®
