7
5
Load Dispenser
Plug In & Turn On
A:
Feed label liner
under
guide
rod and brush
A: Connect power cord (in back)
B: Press power switch (on back) to turn
on machine
B
A
A: Loosen wingscrew to adjust sensor plate
B: Point sensor towards front edge of label
C: Tighten wingscrew to secure sensor
plate in place
QuickSTART
4270 Airborn Dr | Addison, TX 75001, USA
972.248.1999 | service@startinternational.com
www.STARTinternational.com
Need more help? Download the full manual or contact us.
QS03.14
LD6025
LD6050
LD6100
LDX6025
LDX6050
LDX6100
Guide
A
C
Point sensor toward
edge of label
B
B:
Bend liner
around
strip plate
and take-up hub (label will hang
slightly over edge for lifting)
C:
Slide lock rod back into
take-up hub to secure liner
6
D:
Slide small hub lock into
guide rod and rotate clockwise
lightly
until it locks into place
B
C
A
D
LD6050 Model Shown
Small Hub Lock
Slide the hub lock into the rod
Turn the hub lock clockwise
lightly until it locks into place
Now you’re ready to roll.
Adjust Sensor
