Your Electronic Lock is
currently set with the default
combination of:
1-2-3-4-1-2
BIOMETRIC HANDGUN HANGER SAFE
LOCK INSTRUCTIONS
1
LOCK
LIGHT
FINGERPRINT
SCANNER
2
3
4
STEP 2:
Pinch tabs together and slide
out the battery compartment.
STEP 1
:
Twist key
LEFT
(counter-
clockwise) to open door for the first time.
STEP 3:
Insert a 9V battery into battery
compartment & slide battery compartment
back into place.
OPEN:
INSERT BATTERY OR POWER CABLE:
CHANGE YOUR COMBINATION:
STEP 4:
Hold down BUTTON 1
until green
light turns on - lock will beep twice.
STEP 5:
Enter your
current 6-digit combination
- lock will beep twice.
*When opening the safe for the first time, use the factory DEFAULT
COMBINATION: 1-2-3-4-1-2
STEP 6:
Enter your
NEW
6-digit combination
- lock will beep 3 times.
STEP 7:
Re-enter
your
NEW
6-digit combination
- lock will chime.
Your new combination is now installed.
*If lock beeps 5 times, combination was not installed successfully. Restart
from STEP 4.
IMPORTANT!
Test your new combination several times with the door open
to ensure new combination is properly set before closing and locking safe.
BUTTON 1
DEFAULT COMBINATION:
1-2-3-4-1-2
RECORD NEW COMBINATION HERE:
BIOMETRIC FINGERPRINT SCANNER:
STEP 8:
Press ONCE (do NOT hold) biometric scanner
button - lock will beep twice / lock light and finger
scanner will illuminate green.
Press the switch next to the interior light to turn silent mode
ON/OFF.
If you see a continuous red light on - replace battery.
• Lock will go into standby after 10 seconds of inactivity.
• Lock will go into lockout mode for 5 minutes after 5 wrong
combination attempts.
•
Hold down biometric scanner button until lock beeps 5 times.
•
Lock will reset to the default code: 1-2-3-4-1-2 and erase all
registered fingerprints.
STEP 9:
Position finger fully on biometric scanner
- hold until lock chimes.
Biometric Scanner
Button
Red Interior Light
Silent Mode Switch
NOTE:
This safe WILL open with any fingerprint until the first fingerprint
is registered. If it’s still opening with every fingerprint you have NOT yet
successfully registered your fingerprint.
Your Fingerprint is Now Installed Successfully.
*If lock beeps 5 times, lock light flashes red, and fingerprint scanner stays
green, fingerprint was not installed successfully. Restart from Step 8.
SILENT MODE:
BATTERY LIFE:
OPERATING INFORMATION:
RESET LOCK:
