www.stealthtronic.com | sales@stealthtronic.com
user manual
3G listening unit
1
st
Start up
1. Insert the nano-simcard, connect the battery and wait for 1
minute for the device to bootup.
2.
Call the unit and let is pick up your number.
3. When sending commands to the unit, always wait for about
10 – 20 seconds before the unit will send you the command.
It’s important to have the SMS activated with “SMS1”
Name
Command
Command values
Description
Voice detection
VOX
0 - OFF 1- ON
(send SMS VOX1 or VOX0) to activate or deactivate.
Voice during phone
call (Gain)
Simply, for increasing the signal from the microphone, you
use following commands, pressing on the keypad: #01,
#02, to #09 … wait in between the pressing of DTMF tone.
Sensitivity for VOX
detection
SENS
0 - OFF
1 - highest
199- lowest
The higher the number the more noise is needed to acti-
vate. We recommend about 30 for human voice.
VOX sensitivity
hangs up the phone.
VOXSENS
0 - OFF
1 - highest
199- lowest
This command will hang up an already dialed phone call,
if the noise does not go over a set threshold. The interval
is 2 minutes.
This function is useful especially when you have a recor-
ding station, and you are not listening to the unit directly.
It will save you hours of silent recording.
Battery status
BAT
Returns percentage of battery
Ultra-Sleep Mode
(for most battery life)
SLP
0- OFF
1 - 1 hour sleep mode
24 - 24 hours sleep mode
You need to activate VOX before, if you don’t, the unit will
not wake up, even when there is a noise.
Else the unit is in Ultra Sleep Mode, when it will wake up
in set intervals.
For example, SLP3 means that every 3 hours the unit will
wake up. If you wish to turn this function off, you have to
send SLP0 to the unit.
Factory settings
RESET
Factory settings = SLP0, VOX0, VOXSENS0, SENS50
Status of device
STATUS
The device will send you a status report, about all the
commands, battery and signal strength.
Password settings
PASSWORD
000 - No password
001 to 999 - possible number com-
bination for passwords
ex: 777 - Password is set to 777
Choose your password, it always
has to be 3 digits
If you decide to activate password you will have to use it
for further communication with the device.
For example, if you set PASSWORD777 and you will want
to change the sensitivity you will need to
do so like this 777SENS50
Setting a master
number
SET420777123456 OR
SETCALLNUM777123456
Its advised to use the international format for setting the
number for the 3G unit.
Deleting a master
number
DELCALLNUM
This command will erase a master phone number.
Activate Phone call
when password is on.
If the PASSWORD is on and you will dial the device, you
have to punch in the combination 777 to activate the
microphone.
Turn OFF led diode
LED
0 – OFF
1 - ON
Commands:
- variable
