Ste
rlin
g
Po
wer P
ro
d
u
c
ts
C
op
y
rig
h
t
1
6
8
2
3
4
5
WARNING
You will need the manual for the safety warnings and precautions, operating
and maintenance procedures.
Working with batteries is dangerous
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed below may result in
electric shock, fire, explosion and / or serious injury.
If in doubt DO NOT USE this product
Sterling Power Products
Digital Battery Tester
Quick Key guide
1) Negative clamp, clamp onto the negative terminal of the battery to be tested.
2) Red LED to indicate the battery is in poor condition.
3) Yellow LED to show the battery is just not good but may do the job for a short time.
4) Green LED to show battery in good condition.
5) LED screen to show voltage and Cold Cranking amps set.
6) Positive clamp, clamp onto the
Positive
terminal of the battery to be tested.
7)
Set CCA
button to adjust the CCA ( Cold Cranking Amps ) of the battery to be tested.
8)
Load
button to be pushed to administer the test.
7
When unpacking, check to make sure that the product is intact and undamaged. If any parts
are missing or broken, do not use the product and please contact where you purchased the
product to have it replaced or sorted as soon as possible.
12V only per test
for 24-36V + break into 12V banks
Instructions
