background image

 

 

 
 

Manual TOOL F3B 

 

We, Fa. 

STRAT

AIR

,  congratulate for buying 

that model. The Tool F3B is a high 
performance F3B model. The model is a full 
molded carbon product. Alle parts will be 
produced out of high quality molds. The model is nearly ready to fly. Never the less you have to do me finishing 
work. Finally we wish you a lot of fun in building an flying the model. The Tool F3B is a fast and agil RC-model. 
Take care that the model is always in good technical condition because of the high loads during flight. Be aware that 
you fly the model in safe distance of persons and goods. 
 

1. Wing: 
 

Mill a opening into the surface of the movement part (flap, aileron) and put control horns in it. Then glue them.  
           Picture left = aileron 

                         picture middle= flap 

                      picture right = pushrod cover 

 
In front of the control horn an opening 
must be milled to lead the pushrod 
through the wing. Use the M2,5 
windingrod to connect control horn 
with servo. 200mm are enough for the 
whole wing. For one pushrod you 
need around 45mm of the M2,5 rod. 
On both sides screw the M2,5 metal 
clevises. Connect (solder) servos with 
the preinstalled servocables. In the 
middle of the wing, where the servocables are ending, solder the 6-pol MPX connector (female part). That type of 
connector fit optimal in the wing-opening. Fix them with a trop of CA. 
 
 
 
 
 
 
 
 
 

Reviews: