GPS Vehicle Tracking Unit
Installation Guide
Note to Installer -
Please return
these instructions to customer
for future reference
Installation Support:
866-658-1191
support@streeteagle-gps.com
Precautions
12v DC Power only
.
The Vehicle Tracking Unit (VTU) is designed for
negative ground 12V DC systems only. Do not use the
VTU with any other power systems.
Do not disassemble or modify the VTU
.
This could cause electric shock, personal injury or fire.
Do not connect power from a different system to the
VTU. When in doubt of a safe installation, please
contact your local installer.
Do not install VTU in locations that interfere with
airbag operation.
This could cause a risk of accidents and injury.
Use only specified fuse.
When replacing the fuse, please ensure the amp rating
is the same as the previous fuse.
Cautions
Do not let wires get punctured by screws or caught in
moving parts.
Turn car ignition off before making connections.
Connect the Red and White power input leads after all
other connections have been made.
Use a common ground point for all ground wires.
Tape and insulate any loose unconnected wires.
Note on power wire (Red)
When connecting VTU in combination with other electric
devices, be sure the vehicles’ circuit amp rating is higher
than the sum of each component’s fuse.
