Streetwize Accessories:
Sales enquiries:
sales@streetwizeaccessories.com
Technical enquiries:
support@streetwizeaccessories.com www.streetwizeaccessories.com
To inflate tires:
1. Remove valve cap from air valve stem.
Note:
Make sure locking thumb lever is at up position. If necessary, use valve stem adapter.
2. Insert stem connector to valve stem. Make sure connector is pushed to valve stem as far as possible.
3. Press down the locking thumb lever to engage.
4. Set the compressor on/off switch to “on” position by pressing down the section
of switch marked “I”.
Note:
In the event that the tire is completely flat, raise the vehicle using a
recommended jack before inflating the tire.
5. Monitor pressure on air pressure gauge.
Note:
It is recommended to use a separate air gauge to check the
actual inflation pressure. When desired pressure is reached, turn off compressor, turn the locking thumb
lever to up position and remove stem connector from valve stem. Also remove valve stem adapter if applicable.
6. Replace valve cap on valve stem.
To inflate plastic inflatable (balls, air mattresses, rubber rafts, etc.):
1. Check manufacturer’s specification on item to be inflated for correct inflation pressure.
2. Remove valve cap cover from valve stem.
3. Insert proper valve stem adapter into stem connector as far as possible and turn the locking thumb
lever to down position.
4. Insert other end of valve stem adapter into inflatable air valve stem as far as practical.
5. Set the compressor on/off switch to “on” position.
6. Monitor pressure on air pressure gauge. When desired pressure is reached, turn off compressor, turn the locking
thumb lever to up position and remove stem connector from valve stem. Also remove valve stem adapter if
applicable. Replace valve cap on valve stem.
WARNING! EXPLOSION HAZARD
DO NOT EXPOSE BATTERY TO FIRE OR INTENSE HEAT AS IT MAY EXPLODE.
BATTERY CONTAINS NON-SPILLABLE SEALED LEAD ACID BATTERY: IF CASE SHOULD BECOME CRACKED,
DISPOSE OF IMMEDIATELY TAKING ADEQUATE SAFETY PRECAUTIONS TO PREVENT INJURIES OR DAMAGE TO
PERSONS OR PROPERTY. BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
SPECIFICATIONS
Power Supply Battery:
17AH sealed lead acid
Power Supply DC Output:
12-volts nominal.
Air Compressor:
290 PSI
Power Supply Charging Time:
38 hours for the first time charging with AC charger;
34-36 hours to recharge with AC charger and
12-14 hours to recharge with 12-volt DC charger.
Storage Temperature:
Store in a cool dry area.
The WEEE symbol
on this product means that this product should be ethically dismantled or recycled to
minimise environmental impact. Please check with your local authority for more information.
IMPORTANT:
ADDITIONAL SAFETY INFORMATION
This Power Station/Emergency Jumpstart is
NOT
intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised or
have been given instruction concerning use of the Power Station/Emergency Jumpstart by a person responsible
for their safety.
12v
Portable Power Station & Emergency
Jumpstart with Air Compressor
SWPP1
WELCOME
: This product has been carefully engineered and manufactured to give you dependable operation. Please
read this manual thoroughly before operating your new product as it contains the information you need to become
familiar with its features and obtain the performance that will bring you continued enjoyment for many years. Please
keep this manual on file for future reference.
CONTROLS
1. The rotary switch on the left hand side of the unit controls the power to the booster cables.
Always leave this in the “OFF” position except when jumpstarting a vehicle.
2. 12 Volt Power Outlets x2..
3. Battery Test Button
4. Battery Power Indicator &
Charging Indicator LED’s.
5. Reverse Battery Polarity
LED Indicator.
6. Input Charging Socket.
7. Work Light/USB - ON/OFF Switch.
8. USB Socket.
9. 7 LED Work Light.
10. Positive (Red) and Negative (Black)
Booster Crocodile Clips.
11. Compressor ON/OFF Switch.
12. Pressure Gauge.
13. Air Hose and Nozzle Compartment.
14. AC Charger.
15. DC Charging Cord.
CAUTIONS
• Never work alone with this product. Make sure that someone is available to give assistance if needed.
• Wear complete eye and clothing protection. Do not touch eyes while working near battery.
• Do not attempt to remove or replace the battery used in this device. When the battery has reached the
end of it’s useful lifetime, take the entire unit to a battery recycling facility.
• For proper and safe operation of the 12 Volt DC power accessory outlets, do not place anything into it
except the plug of the accessory to be used.
• Remove metal personal jewelry, such as rings, bracelets, necklaces and watches while working with a
lead-acid battery. It can produce a short-circuit that may cause severe burns.
• Never charge or jump-start a frozen battery.
• Never allow clamps (positive & negative terminals) to touch together or to connect the same piece of
metal to prevent short-circuits and arcing.
• Do not operate this device while wearing vinyl clothing. Static electricity may be generated when vinyl
clothing is rubbed.
• This product is not intended for use in the rain or temperatures above 130˚F.
• Use only the provided chargers, cables and clamps. Unauthorized parts may damage the unit.
• This product is not a toy. Keep out of the reach of children.
• Keep battery terminals clean. Be careful to keep corrosion from coming in contact with eyes.
• Do not operate this unit in or around water. Water can damage the unit.
• If battery acid comes into contact with eyes, flush the eyes with water for at least 10 minutes. Seek
medical attention immediately.
• Always turn the Jumpstart Sustem off when not in use. Store in a cool, dry place.
• Do not open the Jumpstart System. There are no servicable parts in the unit. Doing so will void the warranty.
RoHS
COMPLIANT
M17 1RY
IMPORTANT WARNING:
This product is only supplied with a minimal amount of charge at manufacture,
therefore for this product to operate correctly it has to be fully charged for a period of 38 hours
IMMEDIATELY
after purchase, this is essential
BEFORE ANY USE!
& cannot be used
DURING
the charge period. Failure to
adhere to these conditions may invalidate the products warranty.
1
1
2
9
5
6
3
4
7
8
10
11
12
13
10
14
15
SWPP1 Manual AW 2016.qxp_Layout 1 27/10/2016 11:31 Page 1
