C
B
A
E
Ø35mm
WARRANTY
FAUCET INSTALLATION
Connect the braided
supply hoses to the faucet,
hand tight firmly.
1
BEFORE YOU BEGIN YOUR INSTALLATION
Products and specifications shown are subject to change without notice. Please contact our technical support at care@stylishkb.com for any further queries, replacement parts requests, etc.
©2021 Stylish® all right reserved.
Stylish International Inc.
stylish.international.inc
Follow us on Instagram! Check out and let us know your comments
CARE AND CLEANING
TOLL
FREE
+1-855-789-5352
TOLL
FREE
www.stylishkb.com
care@stylishkb.com
For additional technical assistance or for
any questions or concerns about your
kitchen faucet's warranty, please contact
us.
www.stylishkb.com/warranty
CARPI
K-140
KITCHEN FAUCET
Clean the faucet frequently using mild soap or an on-abrasive
cleaner and then quickly rinse with water and dry with soft cloth
only.
Using abrasive cleaners, solvents, acid cleaners or any scrubbing
detergent, polisher or scraper will damage the finish and void the
warranty.
Slide washer and thread the
mounting nut onto threaded
shroud. Turn faucet to desired
handle position. Securely tighten
clamp screws (E)
4
Shut off
water supply
Flush hot and cold
water supply lines
Required tools
Installation by License
Professional Plumber
Flush the water pipe
before installation
Drawings are for
reference only
Do not disassemble
the body
2
5
Ensure there is a Ø35mm
through-hole on the kitchen
counter. Remove the mounting
nut (A) and washer (B) from the
threaded shroud (C).
3
6
Position faucet on the installation
surface. Fit flexible hoses through
hole on countertop or sink.
Before connecting supply hose,
flush supply valves to clear any
debris. Place a bucket
underneath valves and run
water for 5 to 10 seconds. Turn
water off.
Connect hot and cold water
lines to the inlet pipe and tighten
with a wrench until snug.
Do not over tight.
