Splice Program
Heater Program Wireless LAN
SD Power Time
Heater panel
Control panel
Home screen icons
TYPE-Q502S
Quick Reference Guide
Display the Settings panel
Power source type
Change image view
Display/Non-display icons
Start the splicing process (Set icon)
Start the arc test (Arc test icon)
Start the heating process (Heater icon)
View splice data after splicing
Adjust the zoom of a fiber image
Adjust display brightness
Capture a fiber image
To display the Settings panel, tap the
Settings panel icon (
) on Home screen
.
■
Settings panel
■
Home screen
■
New Technology
When the NanoTune™ is applied to poor fiber end face, a
NanoTune™ screen appears. Even in AUTO NanoTune program, the
Nanotune™ is not applied to good end face, and the usual splice
screen is displayed.
NanoTune™
Settings panel icons
While splice program is selected to “AUTO
NanoTune”, the NanoTune
™
analyzes the
cleaved fiber surface and then sets up optimal
splice condition.
The splice error prevention system
Using keypad
Display the menu screen.
Set up Splice Program.
Set up Heater Program.
Play Help Videos.
Log in to Administrator
mode by entering passcode.
Turn on/off the sound.
Long press: Power ON/OFF
Quick press: Reset
