Distribution of MountPads.
Here's how the MountPads should be distributed on the side
of the cabinet frame.
Mounting instructions SIDE BESTÅ 1/2
Content
3M wet wipe
Screws 23mm
(the number varies depending on the size of
the side)
MountPads 40x25mm
(the number varies depending on the size of the side)
1.
Clean the surfaces.
Use the supplied 3M wet wipe to clean the surfaces of
the cabinet side and the Superfront side.
IKEA CABINET BOTTOM
PLANE SURFACE
ABOUT 1 CM
FROM THE
FRONT EDGE
ABOUT 1CM
FROM THE
FRONT EDGE
2.
Attach the MountPads on the frame.
Place the frame on a hard, plane surface with the
backside down. Attach one MountPad in each corner
of the cabinet side and spread the rest as shown in
the picture to the right. Place them about 1 cm from
the front and rear edge.
Note! Do not remove the cover paper from the
MountPads yet!
Continued on back page
3M
VHB™
GB
Surface Cleaner Sachet
For use with 3M™ VHB™ Tapes
FR
Pochette de Nettoyage
A utiliser avec les rubans 3M™ VHB™
DE
Reinigungstuch
Für den Einsatz mit 3M™ VHB™
Finished result
FRONT VIEW
BACK VIEW
LOWER THAN
50 CM.
BEWEEN 51 CM
AND 80 CM.
BETWEEN 81 CM
AND 140 CM.
TALLER THAN
140 CM.
The result varies depending on the size of the frame.
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Safety!
Superfront /+46 8 68 44 18 14 / info@superfront.com / www.superfront.com
