USER MANUAL
TITLE: 80 Watt 4 Channel Mixer Amplifier
MODEL: PA-4080
DISTRIBUTOR/DEALER
80 Watts RMS
APT-Automatic Protection System-protects the amplifier and speakers
10 total inputs-4 Balanced microphone inputs, 4 high impedance microphone
inputs a auxiliary input and a Tape/CD input. All may be used simultaneously
Reverb built with individual control on each channel
External effects loop allows connection of external effects devices or equalizers
RF interference protection on all inputs and outputs
ELECTRICAL CONNECTIONS AND SUPPLY
WARNING:
This appliance must be earthed. Please check that the supply voltage
details given on the rating label (located on the rear panel) are in accordance with
your electricity supply.
FITTED PLUG. This appliance is fitted with a moulded-on plug. If the socket outlets
in the home are not suitable for the plug supplied with this appliance (or the plug
becomes damaged and requires replacement), it should be cut off and an appropriate
three-pin plug fitted as detailed later this section.
IMPORTANT:
A moulded plug severed from the mains lead must be destroyed
immediately. Such a plug with a bared flexible cord is hazardous if engaged in a live
socket outlet.
If the fuse of the moulded-on plug is to be replaced, remove the coloured fuse cover
on the underside of the plug, and use a suitably certified 3A fuse approved by ASTA
to BS1362, i.e., the fuse carries the ASTA mark. The fuse cover must always be
replaced. Never use the plug with the fuse cover omitted. Replacement fuse covers
are available from your local Authorised Service Agent.
INSTRUCTIONS FOR USE. Plug the mains lead into a suitable power socket and
connect your instrument to the input socket of the amplifier with a suitable guitar
lead (this lead is not supplied with the amplifier, but is normally supplied with the
electric guitar). Finally, press the Power Switch to the ON position, the power LED
will glow and your amplifier is ready for use.
WARNING:
If, after you have followed the instructions outlined above, your
Amplifier fails to function, please contact your local distributor. Under no
circumstances remove the rear panel of the Amplifier whilst it is connected to
the mains supply.
Electrical appliances must never be used where there is a danger of water splashing
onto the unit.
Your attention is drawn to the instructions printed on the notice attached to the back
of the Amplifier.
Exposure to extremely high noise levels may cause a permanent hearing loss.
Individuals vary considerably to noise induced hearing loss but nearly everyone will
lose some hearing if exposed to sufficiently intense noise for a prolonged time.
CAUTION:
CHASSIS SURFACE HOT.
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
AVIS:
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR.
ATTENTION:
SUPERFICIE DE CHASSIS CHAUDE.
