background image

Instructions for TA electrical office/work chair

 

 

Characteristics 
 

Office/work chair with high/low lift and electrical controlled centralbrake. 
 

Use:

 

1. Help to get up 

 2. 

Side 

transfer 

 

3. Work chair for varying heights 

 

Important advantages 

 
40 cm. Height variation – covers almost all needs 
Centralbrake is always placed right 
Lock of seat turning and rolling all at once 
Lower primary height than other chairs with turningbase 
All electrical control is placed by the armrest 
Large seating area with extra sturdy padding 
Extra wear resistance padding, non-flammable. 
 

Chair adjustments

 

 
1.

 

Primary height 

Before taking the chair into use, decide what the need for height intervals is. 
Use the normal height 42-82 cm, or choose between 37-77, 47-87 or 52-92 cm from the floor. 
Loosen the screw on the lifting device, lift to the choosen primary height and fix the screw again. 
The chair is fitted with a bottom stop for lowest primary height. 
 
2.

 

Seat depth 

Adjust with the hand level under the seat right rear edge. If the level is loosened the seat can be moved forward by 
pressing the body against the back rest or moved backward by pressing with the legs. The hand level can be turned 
freely to the most appropriate position by pulling it. 
 

WARNING!!! Height and depth must be limited as much as possible, to minimize the risk 
the chair can tip over, when transferring to or out the chair. 
 
WARNING!!!  Before you sit or rise from the chair, when elevated, be sure two of the wheels 
is turning forwards to obtain best stability in the chair. 

 
 
3.

 

Back height 

Adjust with the hand screw on the backside of the back shield. 
 
4.

 

Armrest 

Adjust width by loosening the umbraco screw on the tube on which the armrest is fitted. The lenght can be adjusted by 
loosening the two bolts under the armrestpads. 
 

Electrical adjustment possibilities 

 
5.

 

Lift and brakes 

The controlbox with buttons for lift and brakes is placed on the front edge of the armrest. 
The brakes should be activated when lifting in connection with alightning or transferring. 
 
6.

 

Recharging 

Reviews: