TAGG
--INFERNO 2.0--
USER’S MANUAL
FUNCTION
OPERATION
Power On
Long Press the HOME for 3 secs
Power Off
Long Press the HOME for 3 secs
In Pairing Mode
Blue and Red LED will start Blinking
Blue LED will Blink
Short Press the HOME Button
Short Press the HOME Button
Long Press the Volume “ +” & “-”
Press the “+” & “-” Button
Press the “+” & “-” button while on Call
When Connected
Answer Call
End Calls
Change Track
Volume “+” & “-”
Mic Volume
LED
USB Port
Speaker
Power Button
Volume ”/
Next Song
Volume Button”-”/
Previous Song
Connecting with your Device:
Keep your Bluetooth Device within 3 Ft. while Pairing.
Press the Power button of TAGG Inferno 2.0 earphone for 3 secs.
Blue and Red LED will blink and it means that the earphone is in
the pairing mode.
Now search for Available bluetooth devices in your
Mobile/Laptop/iPad and select TAGG Inferno 2.0 from the list of
available devices.
If prompted, enter password or PIN required “0000”.
If prompted by your mobile phone to connect, click “YES”.
After Successfully connecting Blue LED will flash twice after
every 4 secs.
How to Charge:
Connect to power using Micro USB.
To better protect the battery life, kindly use only the charging
cable provided with the earphone < 5V, 100 mAH-240 mAH.
Allow 1-2 hours to completely charge the earphone.
LED Indications:
While Charging - Red LED is On.
When completely charged there is no light.
When battery is low, Red LED blinks every four seconds twice
and the voice prompt will let you know that battery status.
Pairing Mode- Blue and Red LED starts Flashing.
Reconnect the Earphone:
If the connection is lost, TAGG Inferno 2.0 will try to reconnect
automatically.
If it does not reconnect, kindly press the Power button for 3
secs and reconnect manually through your mobile Bluetooth.
Common Problems and Solution:
Mobile Can’t Find the Earphone:
Kindly restart your phone and the earphone.
There’s always noise and the Bluetooth keeps disconnecting:
The Earphones needs to be charged.
Make sure you are not beyond the signal distance.
Bluetooth is connected but you are unable to listen to music:
Check your setting to adjust the sound on hands free mode.
Some mobiles require you to select the device twice.
Some mobile devices do not have complete stereo Bluetooth
kindly connect the earphone with another device to check if it is
functioning properly.
Bluetooth Password:
“0000”
Maximum Distance:
20 ft.
Red LED is not ON while charging:
This could be due to lack of use of earphone. It needs to be
charged for 30 min before the Red LED occurs.
Reset the Factory Setting:
When the Earphones are off, hold the power button for about ten
seconds until the red led flashes once- RESET.
Thank you so much for buying TAGG Inferno 2.0 Bluetooth
Earphones with Waterproof IPX-7 and Bluetooth v.4.1, echo
elimination technology. Our main goal is to please you with
superior sound quality and comfort combined with convenience
of hands free operation. Here is some useful piece of information
that will help you operate this earphone properly:
