©Tansun Limited 2008 Part No. 042220 Issue. 1
F o l l o w i n g i n f o r m a t i o n i s o n l y f o r E U - m e m b e r s t a t e s :
The use of this symbol indicates that this product may not be treated as household waste. By ensuring this
product is disposed of correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of this product. For
more detailed information about recycling of this product, please contact your local council, your household
waste disposal service or the shop where you purchased the product.
Fig. S
Fig. T
7. Remove the screw (Fig. T) from the side reflector and lift it up away from the heater to remove it. Repeat at opposite end to remove
other side reflector.
8. The lamp the wires should be pulled out of the side slots and the lamp can be lifted up completely (Fig. U). The wires should be
gently pulled so they come out from behind the reflector.
9. The lamp should now be removed from the heater as shown in Fig. V.
10. Refit the new lamp in reverse order ensuring that no wires get trapped and all screws are fully tightened.
Fig. U
Fig. V
Reference Manual
Sorrento IP
Single
UK & EUROPEAN MODELS:
SOR 210IP, SOR 210IP UK, SOR 210IP EU,
SOR 215IP, SOR 215IP UK, SOR 215IP EU,
SOR 220IP, SOR 220IP UK, SOR 220IP EU.
Spectrum House, Unit 1, Ridgacre Road, West Bromwich,
West Midlands, B71 1BW, England.
Tel: +44 (0)121 580 6200 - Fax: +44 (0)121 580 6222
Email: quartzinfo@tansun.com - Website: www.tansun.com
