Wireless Indoor/Outdoor Thermometer & Clock with Remote Sensor
Model 1730
Simple, reliable, accurate…the wireless thermometer & clock allows you to monitor indoor or
outdoor locations from one room. The base station reads indoor conditions, while the remote
sensor wirelessly reports outdoor weather conditions back to the base station for an all-in-one
weather display.
NOTE:
Some stations have a static cling label over the digital display. Please remove it before use.
BATTERY INFORMATION
IMPORTANT:
Install batteries in the base station first, then the remote sensor, otherwise the
stations’ transmissions may not properly connect. Place the base station as close as possible to
the remote sensor when installing batteries.
Base Station:
The base station operates on 2 AAA batteries (not included). The battery compartment is located
on the back of the station. Remove the battery compartment door. Install (2) AAA size batteries
into the battery compartment according to the polarity markings. Replace the battery
compartment door.
Remote Sensor:
The remote sensor operates on 2 AAA batteries (not included). The battery compartment is
located on the back of the station. Slide off the battery compartment cover. Install (2) AAA size
batteries into the battery compartment according to the polarity markings. Replace the battery
compartment door.
After Batteries are Installed:
When the stations are powered up, the LCD screen on the base station will light up for 3 seconds,
then the station will display initial indoor temperature readings. The outdoor temperature
display will show dashes “(--)”.
Press and hold the button on the front of the base station to activate the paring to obtain
outdoor temperature. A transmission signal icon (“ ”) flashes by the “OUT” temperature digits
during this time. When the “ ” icon turns off, the base station has connected with the remote
and starts reporting the current outdoor temperature.
