Installation Instructions for
Voto Pathway
920OAVOTO
G
P
I
:
ENERAL RODUCT NFORMATION
This product is suitable for wet locations.
12VAC input only.
If using Tech Lighting magnetic transformers, this product be
dimmed with a low-votage magnetic dimmer. For all other
transformers, consult with the manufacturer for compatible
dimmers.
CAUTION RISK OF FIRE
-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
OUTDOOR
Loosen
the four set screws on fixture
(Do Not Remove)
base with the provided Allen wrench and remove the
base plate.
1
Prepare the Fixture
1
700OAVOT_
1.1
2A
Attach the stake to the base plate by tightly screwing
down the provided stake bolt through the center hole
of the base plate and the stake.
Reattach the base plate assembly to fixture and tighten
down the set screws on the canopy (reversal of Section
1A).
1
STAKE
STAKE BOLT
BASE PLATE
2
Install the Fixture using a Stake
(with canopy)
Determine the method of installation:
Install the fixture using a stake
, go to
with a canopy
Section 2.
Install the fixture using a stake
, go
without a canopy
to Section 3.
Install the fixture
, go to Section 4.
without a stake
WARNING
– Risk of Electric Shock. Install all luminaires
10 feet (3.05 m) or more from a pool, spa, or fountain.
Unit low voltage cable is to:
a) be protected by routing in close proximity to the
luminaire or fitting, or next to a building structure such
as a house or deck;
b) not be buried except for a maximum 6 inches (15.2
cm) in order to connect to the main low voltage cable;
and
c) have the length cut off so that it is connected to a
connector within 6 inches (15.2 cm) from a building
structure, a luminaire, or fitting.
2
1A
ALLEN
WRENCH
1
1
1
1
BASE PLATE
SET SCREW
1
