Begin by cleaning the screen with the Wet
Wipes and the Microfiber Cleaning Cloth.
Using your index finger, swipe down the
middle of the screen, making the protector
begin to adhere to the phone. At this step, only
the middle of the protector will be attached to
the phone.
Remove the installation tray from the phone.
On the right-hand side of the phone, take the
squeegee and FIRMLY push from bottom to
top, pushing the air out of the TOP of the
phone.
Remove any case from the phone. Place
the Easy Installation Tray on the phone,
aligning the top of the tray with the top of
the phone.
Peel off the mask film to expose the
adhesive surface of the screen protector.
Using the Easy Installation Tray as an
alignment guide, line up the top or bottom
of the protector and carefully place the
protector on the phone.
FIRMLY repeat on the left side of the phone,
directing air to come out of the TOP of the
phone.
If there are any bubbles, lift the NEAREST
corner to the bubble, and re-squeegee that
area. Repeat until all bubbles are gone.
