background image

 

RD000519Rev A 

AC-211N 

   

Installing the Access 211N VoIP  Gateway 

 

Access 211N Gateway Rear Panel 

 

Important Safety Instructions : 

 

When using the  Access 211N Gate way and the attache d tele phone set, basic safety 
pre cautions should always be  followe d to re duce  the risk of fire , ele ctric shock and 
injury to pe rsons, including the  following: 

1.

 

Do not use  this e quipment ne ar  wate r, for example, ne ar  a  bath tub,  wash  bowl, 

kitchen sink or laundry tub, in a wet basement or near a swimming pool.  

2.

 

Avoid using  the e quipment  during an ele ctrical storm.  The re  may  be  a  remote   risk 

of ele ctric shock  from  lightning. 

3.

 

Do not use  the  attache d tele phone  to  re port  a gas leak in the  vicinity of the le ak. 

4.

 

Do not cove r the  unit or block ventilation inle ts.  

 

The  Access 211N Gate way must be  powe re d by an exte rnal UL liste d limite d powe r 
source or Class II powe r source  (AC /DC  adapte r), rate d input: 100 -240 V, 47-63Hz , 
0.5A, output: 5VDC  @ 2A. 

The   phone   ports  (PH1  and  PH2)  are   intende d  for  indoor  connections  only  and  must  not 
be  conne cte d to the  Public Tele communication Ne twork.

 

 

Summary of Contents for Access 211N

Page 1: ... or laundry tub in a wet basement or near a swimming pool 2 Avoid using the equipment during an electrical storm There may be a remote risk of electric shock from lightning 3 Do not use the attached telephone to report a gas leak in the vicinity of the leak 4 Do not cover the unit or block ventilation inlets The Access 211N Gateway must be powered by an external UL listed limited power source orCl...

Page 2: ...ystem components are properly installed Make sure that all cable connectors are securely positioned in the appropriate ports 6 Connect the power adapter tothe power connector of the unit andto the power source 7 Check that the Power LED on the Gateway front panel glows steadily 8 Turn on your PC 9a If you are using a DSL modem you will need to enable PPPoE on the Gateway and disable PPPoE on your ...

Page 3: ...he front if the gateway to glow indicating you are connected to your VoIP service providers It may take a minute or two for these connections to be established 11 Verify that youhave Internet access 12 Pick up the phone on each line to verify that you can hearthe dial tone Once the installation is complete you can use your Access 211N Gateway for telephone calls and for the Internet assuming that ...

Page 4: ...are using a cable modem note that some cable modems need to be power cycled after being connected to the Gateway For such modems you can also power cycle the Access 211N Gateway for faster connection 9 Wait for the respective Phone Voice LED Phone1 for PH1 port Phone2 for PH2 port on the Gateway front panel to glow indicating connection to your Internet and VoIP providers It may take a minute or t...

Reviews: