background image

581-504 4 ½” OD Single Post 4 Seat Swing

 
 

* IMPORTANT * 

Please retain this instruction sheet in your files.  It contains important replacement 
parts information.  All equipment should be installed in accordance with these 
instructions.  It is important to use and maintain all public playground equipment 
properly.  Playground equipment, which is improperly maintained, can cause serious 
injury.  Periodical inspections, maintenance, repair and/or replacement of damaged parts 
is necessary for safe operation of equipment and safety of users.  Resilient surfacing 
should be used under all playground equipment.  Appropriate publications, available at no 
charge, from the Consumer Product Safety Commission, include “A Handbook for Public 
Playground Safety”.  You can receive your free copy by calling 1-301-504-0708. 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

PACKING LIST

HARDWARE BAG

1  CTN 

 

Hardware Bag 

4

196-802 

½” x ½” Socket Set Screw 

2  PIPE 

583-510 

4 ½” OD x 11’4” End Post 

8

317-140 

4/0 Chain x 5’6” long 

2  PIPE 

343-210A 

2 3/8” OD x 11’ Top Rail 

1

416-400 

¼” Socket Key 

1  PIPE 

583-511 

4 ½” OD x 11’4” Center post 

8

585-520 

2 3/8” Swing Hanger 

  

 

 

16

585-901  S-Hook 

 

 

 

 

4

585-955 

Cut Proof Belt Seat 

  

 

 

1

805-532  Warning 

Label 

  

 

 

1

805-534  SportsPlay 

Label 

  

 

 

1

 

Maintenance 

Checklist 

 
 
 
 
 
 
 
 
 

1 CTN     

5 PIPE 

6 TOTAL PCS

TOTAL WT 495#

CLASS 70

Summary of Contents for 581-504

Page 1: ... of users Resilient surfacing should be used under all playground equipment Appropriate publications available at no charge from the Consumer Product Safety Commission include A Handbook for Public Playground Safety You can receive your free copy by calling 1 301 504 0708 PACKING LIST HARDWARE BAG 1 CTN Hardware Bag 4 196 802 x Socket Set Screw 2 PIPE 583 510 4 OD x 11 4 End Post 8 317 140 4 0 Cha...

Page 2: ...sizes up to 5 diameter Varying soil climatic conditions may require deeper heavier footings in some areas Check local building codes Diagram Diagram Permanent Installation Suggested Bracing Method If resilient surfacing is to be less than 12 then additional pipe should be put in concrete to maintain proper finish grade for equipment USE AREA FOOTING LAYOUT ...

Page 3: ...of the swing plus six feet The six foot minimum fall zone from the supporting structure also applies and may overlap the six foot zone of an adjacent swing structure GENERAL MAINTENANCE INSTRUCTIONS Check MONTHLY for loose bolts damaged or broken parts Tighten and or replace immediately On swings and any equipment that uses S Hooks and or Swing Hangers check the bearing surfaces for wear Replace a...

Page 4: ...P 6 Plumb and level entire unit Use short length of pipe on end of socket key to add leverage when tightening socket set screws Pour concrete Dome top of cement for proper drainage Wait 48 hours before removing braces applying resilient surfacing and using equipment STEP 7 Attach assembled seats to swing hangers by reattaching the bearing hooks to the swing hangers SEE STEP 2 OD NOT overtighten bo...

Reviews: