Page 1 of 2
Version: 2
First start by assembling corners. There are three (3) brackets per corner. All extrusion sections are numbered to identify which
pieces go together, 1 with 1, 2 with 2, etc.
1. Insert the flat L brackets with the four (4) set screws into the back of one extrusion segment as shown. Identical bracket with no
holes goes between bracket and the extrusion, as shown in the images below. Lightly screw into place, DO NOT fully tighten.
2. For Bent Corner Bracket:
Insert the bent bracket into the same extrusion section. Firmly screw the bracket into place. Take the
mating extrusion piece with matching number. Guide the corner brackets in, then tighten all brackets.
3. Repeat assembly steps for the three remaining corners (not shown).
4. Install white backing graphic (
See additional page for detailed instructions)
.
5. WALL MOUNT OPTION:
Drill mounting holes in the frame channel as needed, to align with the EXISTING WALL STUDS
. Using an X-acto
blade or hole puncher, puncture or cut small holes into the white backing graphic to match the holes just drilled in the frame, then
mount to the wall
(Mounting screws and anchors not provided).
Install front graphic
(See additional page for detailed instructions)
.
6. Install the graphic (
See additional page for detailed instructions)
.
NOTE: Model shown below may differ from your model, but assembly instructions remain the same.
Charisma™ LED Single Sided Light Box - XBX Series - Without Lights
6. Graphic Installation
(see next page)
4. Backing graphic Installation (see next
page)
White Backing Graphic
XBX34 shown
Wall Mount Holes
are drilled by
customer at time
of installation.
5.
Screw
2a.
White
Backing
Graphic
2c.
1
1
1
1
2b.
1.
Bracket A
Bracket B
Bracket A
Bracket B
